Quick Info :
Operating Voltage : 5V
Pin pitch : 2.54mm
Operating Current : 500mA (MAX)
Total Size : 25 x 17 x 10mm/1 x 0.68 x 0.4in(L*W*H)
Rs 100.00
Quick Info :
Voltage: 3.3V, 5V
Output load voltage :0-24V
Output load current: <5A (1A need to add more heat sink)
Rs 250.00
Quick Info :
Eight 7-Segment LED Displays with 0.36″ high red digits
LED displays mounted in sockets
Built-in MAX7219 LED Driver
SPI 3-wire serial interface for easy hookup to MCU
Can daisy-chain multiple modules together for larger displays
Rs 590.00
Quick Info :
uses the 5050 full-color LED
Operating voltage: 5V
by adjusting the three primary colors can be mixed PWM get different colors
Rs 100.00
Quick Info :
Module Size: 2.8cm * 1.3cm
Applicable connector: 5.5 * 2.1mm
Power output interface: 2 channel VCC, 2 channel GND
Net Weight: 3.2g
Rs 100.00
Quick Info :
Input Voltage: 6 ~ 27V
Driver: Dual BTS7960 H Bridge Configuration
Peak current: 43-Amp
Rs 1,790.00
Quick Info :
Operating Voltage: DC 4.5V-35V
Control Power: 90W (maximum)
Size: 30mm x 26mm x 14mm (Without Handle)
Rs 590.00
Quick Info
Supply voltage (typically): 3.3V
Battery not included
Battery : CR2032
Rs 790.00
Quick Info :
Arduino and Raspberry Pi compatible
16-key membrane switch pad has 8 pin female header on end of flat cable
White sticker on back can be peeled off for adhesive mounting
Rs 290.00
Quick Info :
Compatible Motors: Nema 17/23/34(42/57/86 Stepper Motor)
9V-42V DC power supply;
H-bridge bipolar constant-phase flow-driven;
maximum output current of 4.0A eight optional
Rs 1,650.00
Quick Info :
Channel : 8
Coil sensitivity = 5VDC
Maximum Contact capacity = 250VAC/10VDC
Maximum Current capacity = 10A
Rs 1,390.00
Quick Info :
16 Channel
Maximum switching voltage: 250VAC / 30VDC
Maximum switching current: 10A
Module operating voltage: 5V
Rs 2,950.00
Quick Info :
Four 7-Segment LED Displays with 0.36″ high red digits
Built-in TM1637 LED Driver
2-wire serial interface for easy hookup to uC
3.3 and 5V compatible
Rs 390.00
Quick Info :
12-key membrane switch pad has 7 pin female header on end of flat cable
White sticker on back can be peeled off for adhesive mounting
Rs 250.00
Quick Info :
Option 1 : DB9 Connector
Option 2 : DB9 and DB25 Connectors
Rs 850.00 – Rs 990.00
Quick Info :
16 bi-directional channels
Can be used as multiplexer or demultiplexer
Channels can handle analog or digital signals
Rs 290.00
Quick Info :
240*320 pixels
Suitable for an Uno (Atmega328P) or Mega (Atmega2560) based Arduinos (other chips are not supported)
Dimensions: 72.5 mm x 53 mm
Driver: ILI9320 or ILI9341 (or compatible with one of two)
Rs 2,250.00
Quick Info :
Channels : 1
Input release voltage: 3.5 to 5V
Rated load voltage: 100V to 240V AC
Load current: 0.10 to 2A
Rs 600.00
Quick Info :
Dual-Band 900/ 1800 MHz
GPRS multi-slot class 10/8GPRS mobile station class B
Compliant to GSM phase 2/2+
Recommended Power Supply – 5V 2A
Rs 2,850.00
Quick Info :
Max. Operating Voltage: 45 V
Min. Operating Voltage: 8.2 V
Max. Current Per Phase: 2.5 A
Alternatives for DRV8825 : A4988 , TMC2209
Rs 590.00
Quick Info :
Material: ABS
Dimension(LxWxH): 43.7×30.5×5.3mm
Response Frequency: 13.56MHz
Chip type: FM1108 Fudan Chip
Rs 100.00
Quick Info :
Support Card Type: Read-only ID card (EM4100, IM4001)
Support frequency: 125KHz
Reader Time: <0.2s
Read Range: 3-10cm
Rs 990.00
Quick Info :
Resolution 640×480 VGA
Flicker (50/60 Hz) auto detection
Onboard regulator, only single 3.3V supply needed
Rs 590.00Rs 925.00
Quick Info :
Max. Operating Voltage: 28 V
Min. Operating Voltage: 4.75 V
Max. Current Per Phase: 2 A
Alternatives for TMC2209 : DRV8825, A4988
Rs 3,250.00
Quick Info :
A single module can drive a total of 8 * 8 dot matrix overcast
The module voltage: 5V
Module Size: 12.8 cm (length) X 3.2 cm (width) X 1.3 cm (height)
Rs 1,650.00
Quick Info:
Working voltage: 6 to 18V
Dual channel 15W+15W
on-board dial potentiometer
Rs 590.00
Quick Info :
WIZnet W5500 Ethernet controller
Compatible withWIZ850io
Magjack RJ-45 CAT network connector
Acts as client or server
TCP/IP protocols include TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE
10BaseT/100BaseTX Ethernet PHY embedded
Rs 2,290.00
Quick Info :
Low Freq. range – 820-960mHz
High Freq. range – 1710-1990mHz
Cable – RF1.13
Connector – I-PEX
Rs 300.00
Quick Info :
Operating Voltage is 4.7V to 5.3V
Current consumption is 1mA without backlight
Alphanumeric LCD display module, meaning can display alphabets and numbers
Consists of four rows and each row can print 16 characters.
Compatible with LCD to I2C Adapter Board
Rs 850.00
Quick Info
Operating Voltage : 9 – 12 V (Preferred 12V)
Case (L x W x H) : 53 x 40 x 28mm (2.1 x 1.6 x 1.1″)
Latch (L x W) : 10 x 10mm (0.4 x 0.4″)
Rs 2,590.00
Quick Info :
5-18V power supply supported.
Serial USB TTL compatible for 2.85V, 3.3V and 5v signal
GSM, GPRS, GPS {text messaging, data transmission, positioning} triple function.
Rs 4,000.00Rs 4,300.00