Quick Info :
Channel : 4
Coil sensitivity = 5VDC
Maximum Contact capacity = 250VAC/10VDC
Maximum Current capacity = 10A
Rs 590.00Rs 790.00
Quick Info :
Voltage: 3-3.6V (recommended 3.3V) V.
Maximum output power: +20dBm.
Power-down mode current: 4.2uA.
Operating Range: 1Km
Rs 600.00Rs 850.00
Quick Info:
Chipset : TDA8932
Operating Voltage : DC 10V – 30V
Output Power : 35W
Speaker Impedance : 4 – 8 Ohm
Rs 600.00Rs 750.00
Quick Info :
Total Resistance : 10KΩ
Wiper Tap Positions : 100
Step Resolution : ~101Ω per Step
Operating Voltage : 3V – 5V DC
Memory Type : Non-Volatile
Rs 640.00Rs 750.00
Quick Info :
WIDE SUPPLY RANGE: 2.0V to 5.5V
PROGRAMMABLE DATA RATE: 8SPS to 860SPS
Rs 650.00Rs 950.00
Quick Info :
Resolution 640×480 VGA
Flicker (50/60 Hz) auto detection
Onboard regulator, only single 3.3V supply needed
Rs 680.00Rs 925.00
Quick Info :
OLED Driver IC: SSD1306
Color: White
Resolution: 128 x 64
Visual Angle: >160°
Input Voltage: 3.3V ~ 6V
Compatible I/O Level: 3.3V, 5V
Rs 680.00Rs 990.00
Quick Info :
4mm detection distance with ±10% accuracy
Adjustable sensitivity range: 0-3.8mm
Detects magnetic and non-magnetic metals
Built-in LED indication for switched state
IP67 waterproof protection rating
3-wire connection: VCC, GND, NPN NO output
Rs 690.00
Quick Info:
Compatible MCUs : STM8 & STM32 Series
Protocols : SWIM, SWD, JTAG
Host Interface : USB 2.0 Type-A
Power Supply : Bus-Powered via USB
Compatible IDEs : STM32CubeIDE, Keil, IAR
Operating System : Windows, Linux, macOS
Rs 690.00Rs 725.00
Quick Info:
Voltage Range : 0 – 100V DC
Current Range : 0 – 10A DC
Display : Dual LED Display
Shunt Included : Yes
Accuracy : ±1%
Power Supply : 4.5 – 30V DC
Mounting : Panel Mount
Rs 690.00Rs 725.00
Quick Info :
Stackable design, easy to plug into the ARDUINO development board.
Coupled with the Arduino Bluetooth Bee Bluetooth module, and other Bluetooth devices can communicate Wirelessly.
Coupled with the XBee module, you can achieve two or more sets of communication between Arduino or Arduino and PC Communications.
Rs 750.00
Quick Info :
Type: Hard plastic push button keypad
Keys: 12 (0-9, *, #)
Interface: 7 pins (4 rows + 3 columns)
Pin Pitch: 2.54mm through-hole PCB
Mounting: 4 corner mounting holes
Housing: Black ABS plastic
Compatible: Arduino, ESP32, Raspberry Pi
Rs 750.00Rs 850.00
Quick Info:
Current : 0A ~ 6A
Operating Voltage : 0V ~ 15.2V
Power : 60W
Temperature Range : -30C to 70C
Rs 780.00Rs 850.00
Quick Info :
Standard USB type A male and TTL 5 pin connector.
5 pins for 3.3V, TXD, RXD, GND & 5V.
Baud rates: 300 bps to 1.5 Mbps
Rs 790.00Rs 850.00
Quick Info :
Bluetooth: Version 5.0
Power: USB + Battery
Features: Calls, Sound Card, Charge-while-use
Audio: Lossless FLAC/APE/WAV/MP3
Rs 800.00Rs 900.00
Quick Info :
Type: Hard plastic push button keypad
Keys: 16 (0-9, *, #, A-D)
Interface: 8 pins (4 rows + 4 columns)
Pin Pitch: 2.54mm through-hole PCB
Mounting: 4 corner mounting holes
Housing: Black ABS plastic
Compatible: Arduino, ESP32, Raspberry Pi
Rs 800.00Rs 900.00
Quick Info:
Flash Memory : 16Mbit (2MB) Onboard
Supported Formats : MP3, WAV
Control Interface : UART Serial, I/O Trigger, Push Button
Operating Voltage : 3.3V – 5V DC
USB Interface : Micro USB (file upload)
Rs 840.00Rs 900.00
Quick Info :
Antenna Type : Active (LNA + SAW filter integrated)
Center Frequency : 1575.42MHz (GPS L1)
Frequency Bandwidth : 1575.42 ± 5MHz
Polarisation : RHCP (Right-Hand Circular Polarisation)
Impedance : 50Ω
Cable Length : 1.5 metres
Connector : SMA Male (straight)
Rs 850.00Rs 1,100.00
Quick Info :
LED Type : SMD2812
Light Colors : RGB (Red, Green, Blue – Mixable for millions of colors)
Length : 1 Meter
Qty: 60 LEDs/meter
Voltage : 5V DC
Power Consumption : 7.2W – 14.4W per meter
Luminous Flux : 500 – 1200 lm/m
Rs 850.00
Quick Info :
Type: 44-pin expansion breakout board
Compatible: ESP32-S3 development boards
Terminals: Screw terminal blocks (1→2 expansion)
Spacing: 25.4mm (44-pin)
Size: 80mm x 58mm
No Soldering Required
Rs 850.00Rs 950.00
Quick Info :
Chip: PCM5102
Resolution: Up to 32-bit/384kHz
Interface: I2S
Power: 3.3 V – 5 V DC
Rs 850.00Rs 1,050.00
Quick Info:
Interface : USB 3.0
Supported Cards : SD, TF (MicroSD)
Transfer Speed : Up to 5 Gbps
Compatibility : Windows, macOS, Linux
Driver Required : No (Plug and Play)
Power : Bus Powered via USB
Rs 850.00Rs 950.00
Quick Info:
Frequency : 433MHz
Modulation : ASK/OOK
TX Range : Up to 100 Meters
Supply Voltage : 1.2V – 6V (TX) / 2.4V – 5.5V (RX)
Rs 850.00Rs 950.00
Quick Info :
Temperature measurement and programming range: -50°C …110°C
Measurement accuracy: 0.1°C in the range from -9.9°C to 99.9°C; or 1.0°C outside this range
Control accuracy: 0.1°C 0.1°C in the range -9.9°C to 99.9°C; or 1.0°C outside this range
Hysteresis accuracy: 0.1°C
Reading update time: 0.5 seconds
Supply voltage, V: 110-220 AC
Rs 890.00
Quick Info :
Bluetooth Version : V2.0+EDR
Operating Mode : Slave Only
Input Voltage : 3.6V to 6V
Logic Level : 3.3V
Default Baud Rate : 9600 bps
Range : Up to 10m (Open Area)
Rs 950.00Rs 1,350.00
Quick Info :
Complies with wireless 802.11n standards
Frequency band: 2.4~2.4835GHz
Data rate up to 150Mbps
Rs 950.00Rs 1,250.00
Quick Info:
Control Type : Bidirectional SCR (Thyristor)
Input Voltage : AC 220-230V, 50/60Hz
Output Voltage : AC 50V to 220V, adjustable
Maximum Power : 2000W (resistive load)
Maximum Current : Up to 25A
Rs 950.00Rs 1,250.00
Quick Info :
CAN Controller : MCP2515
CAN Transceiver : TJA1050
Operating Voltage: 5V
Interface: SPI
Rs 950.00Rs 1,250.00
Quick Info :
Support WS2811 WS2812B LED LED lights. It can’t control SK6812 RGBW and regular RGB LED lights without a driver IC. 300+ color modes include rainbow, wave, breathing, strobing, gradual change, color cycle, comet, static, fading, and chasing. Color-changing speed and brightness are adjustable.
Rs 950.00Rs 1,100.00
Quick info :
Operating voltage: DC12V;
Operating current: <20MA;
Operating frequency range: 20Hz ~ 400Hz;
Output mode: switch signal output;
Maximum detection wire diameter: 5.2mm;
Rs 950.00
Quick Info :
True TFT display with 262,144 vibrant colors
4-wire SPI interface – minimal pin usage
Works with 3.3V and 5V systems
Built-in microSD card slot for bitmap storage
Compatible with Arduino, Raspberry Pi, ESP32
Controllable LED backlight
Compact 34.5×58.0mm PCB size
Rs 950.00Rs 1,250.00
Quick Info :
FT232RL+75176 chipset for stable communication
Automatic data flow control – no manual DE/RE control
Supports up to 32 devices on RS485 bus network
Wide baud rate: 300-921600bps with auto-detection
Switchable RS485/TTL modes via 4 jumpers
TVS protection and USB self-recovery features
Self-powered from USB – no external power needed
Rs 950.00
Quick Info :
Type: RJ45 Female to 8-Pin Terminal
Pins: 8
Compatible Cables: Cat5 / Cat6
Material: Plastic
Voltage: ≤50 V
Rs 950.00Rs 1,150.00
