Quick Info :
Dimensions : 31mm X 15mm X 5mm / 1.22 X 0.59 X 0.19 inch
Rs 100.00
Quick Info :
Fully compliant USB 2.0 standard, backward compatible with USB1.1
Support System: Windows XP, Vista, Windows 7, Linux, MacOS, and WinCE5.0 drive
Supports Plug, Play and hot-swap ( USB side) ;
Rs 450.00
Quick Info :
Standard USB type A male and TTL 5 pin connector.
5 pins for 3.3V, TXD, RXD, GND & 5V.
Baud rates: 300 bps to 1.5 Mbps
Rs 790.00
Quick Info :
Connector Type: USB Type -B
PCB Size: 20 x 20 mm
Weight: 4g
Rs 100.00
Quick Info :
Built-in USB to TTL Transfer chip.
Designed to be used for USB to TTL electronic projects.
TTL interface output. easy to connect to your MCU.
Rs 490.00
Quick Info :
Voltage: 3.7 – 5V DC
Bluetooth Version: 5.0 (Backward compatible with Bluetooth 4.2, 4.1, 4.0)
Transmission Distance: 15m (Visible)
Audio Decoding: WAV, APE, FLAC, MP3
Dimensions: 30mm x 30mm
Rs 480.00
Quick info :
Detection Voltage Range DC: 3.5-130V（max）
Voltage Sampling Period : 300ms/ second
Input Impedance : >100KΩ
Working Current : <10mA
Rs 450.00Rs 500.00
Quick Info :
Temperature range: -50 -110°C
Dimensions: 48.5 * 40mm
Temperature control mode: ON / OFF
Control accuracy: 0.1 °C
Output voltage: DC 12V
Rs 750.00
Quick Info :
Temperature measurement and programming range: -50°C …110°C
Measurement accuracy: 0.1°C in the range from -9.9°C to 99.9°C; or 1.0°C outside this range
Control accuracy: 0.1°C 0.1°C in the range -9.9°C to 99.9°C; or 1.0°C outside this range
Hysteresis accuracy: 0.1°C
Reading update time: 0.5 seconds
Supply voltage, V: 110-220 AC
Rs 890.00
Quick Info :
Operating voltage:5V (supplied from the Arduino Board)
Ethernet Controller: W5500 with internal 32K buffer
Connection speed: 10/100Mb
Connection with Arduino on SPI port
Rs 4,390.00
Quick info :
Operating voltage: 6 – 30V DC
1 Channel delay triggered relay module
Delay time: 0.1 second to 999 minutes
Rs 590.00
Quick Info :
Channels : 1
Input release voltage: 3.5 to 5V
Rated load voltage: 100V to 240V AC
Load current: 0.10 to 2A
Rs 600.00
Specification:
Size: 1.28inch
Resolution: 240 × 240
Driving chip: GC9A01
Interface method: SPI
Color: Full-color RGB
Rs 2,190.00
Quick info :
Display Size: 1.8″
Driver IC: ST7735
Input Voltage (V): 3.3 to 5
Pixel Resolution: 128 x 160
Interface Type: SPI
Rs 1,490.00
Quick info:
Plug-and-Play: Easy setup with USB 2.0 interface
Compatibility: ISO 14443 Type A/B, ISO 15693, and NFC cards
Data Transfer speed: 106 kbps, 212 kbps, and 424 kbps
Power Supply: 5V DC
Rs 2,100.00
Quick Info :
Support Card Type: Read-only ID card (EM4100, IM4001)
Support frequency: 125KHz
Reader Time: <0.2s
Read Range: 3-10cm
Rs 990.00
Quick Info :
Material: ABS
Dimension(LxWxH): 43.7×30.5×5.3mm
Response Frequency: 13.56MHz
Chip type: FM1108 Fudan Chip
Rs 100.00
Quick Info :
240*320 pixels
Suitable for an Uno (Atmega328P) or Mega (Atmega2560) based Arduinos (other chips are not supported)
Dimensions: 72.5 mm x 53 mm
Driver: ILI9320 or ILI9341 (or compatible with one of two)
Rs 2,250.00
Quick Info :
Channels : 4
Input release voltage: 3.5 to 5V
Rated load voltage: 100V to 240V AC
Load current: 0.10 to 2A
Rs 1,600.00
Quick Info :
Degree: 4 Degree of Freedom
Material: Acrylic
Compatible Servo: 4 Micro Servos MG90 (Not Included
Rs 1,390.00
Quick info :
Operating voltage: DC12V;
Operating current: <20MA;
Operating frequency range: 20Hz ~ 400Hz;
Output mode: switch signal output;
Maximum detection wire diameter: 5.2mm;
Rs 950.00
Quick Info :
Frequency – 1559Mhz-1609Mhz
Active antenna noise figure < 1.5dB
Cable – RF1.13
Connector – I-PEX
Rs 650.00
Quick Info :
WIDE SUPPLY RANGE: 2.0V to 5.5V
PROGRAMMABLE DATA RATE: 8SPS to 860SPS
Rs 1,750.00
Quick Info :
Real Time Clock Module : DS1307
SD Card reader : standard SD card
RTC battery included
Rs 690.00
Quick Info :
Stackable design, easy to plug into the ARDUINO development board.
Coupled with the Arduino Bluetooth Bee Bluetooth module, and other Bluetooth devices can communicate Wirelessly.
Coupled with the XBee module, you can achieve two or more sets of communication between Arduino or Arduino and PC Communications.
Rs 750.00
Quick Info :
A single module can drive a total of 8 * 8 dot matrix overcast
The module voltage: 5V
Module Size: 12.8 cm (length) X 3.2 cm (width) X 1.3 cm (height)
Rs 1,650.00
Quick Info :
Perfect for experimentation and prototype work
Brings all 9 pins of a DB9 connector to screw terminal blocks
Adapter used for communication debug
9 pcs signal line was all lead out, name and number clearly labeled;
Rs 290.00
Quick Info :
Module Size: 2.8cm * 1.3cm
Applicable connector: 5.5 * 2.1mm
Power output interface: 2 channel VCC, 2 channel GND
Net Weight: 3.2g
Rs 100.00
Quick Info :
Max. Operating Voltage: 45 V
Min. Operating Voltage: 8.2 V
Max. Current Per Phase: 2.5 A
Alternatives for DRV8825 : A4988 , TMC2209
Rs 590.00
Quick Info
Supply voltage (typically): 3.3V
Battery not included
Battery : CR2032
Rs 790.00
Quick Info :
Operating voltage : 2.3V – 5.5V
Battery not included
Battery : CR2032
Rs 590.00
Quick Info :
ENC28J60 Ethernet chips, SOP28 package
SPI Interface
Single Supply: +3.3 V
Rs 990.00
