-
Micro SD Card Reader Module SPI
Quick Info:
- Interface : SPI (MISO, MOSI, SCK, CS)
- Operating Voltage : 4.5V to 5.5V DC
- Logic Level : 3.3V and 5V
- Supported Cards : Micro SD (up to 2GB), Micro SDHC (up to 32GB)
- Header : 6-pin
Rs 350.00Micro SD Card Reader Module SPI
Rs 350.00 -
3-Channel CCPM Servo & ESC Tester
Quick Info:
- Channels : 3
- Operating Voltage : 4.8V to 6V DC
- Output Signal : 1.5ms ± 0.5ms
- Test Modes : Manual, Neutral, Automatic
- Connectable Devices : Up to 3 servos or 3 ESCs
Rs 350.00Rs 450.003-Channel CCPM Servo & ESC Tester
Rs 350.00Rs 450.00 -
USB to TTL Converter CP2102 (5 Pin)
Quick Info :
- Standard USB type A male and TTL 5 pin connector.
- 5 pins for 3.3V, TXD, RXD, GND & 5V.
- Baud rates: 300 bps to 1.5 Mbps
Rs 790.00Rs 850.00USB to TTL Converter CP2102 (5 Pin)
Rs 790.00Rs 850.00 -
5V Relay Module Optocoupler High/Low Trigger
Quick Info:
- Operating Voltage : 5V DC
- Trigger Mode : High/Low Level
- Max Load : AC 250V/10A, DC 30V/10A
- Isolation : Optocoupler
Price range: Rs 280.00 through Rs 780.00 -
PCM5102 DAC I2S Interface Decoder
Quick Info :
- Chip: PCM5102
- Resolution: Up to 32-bit/384kHz
- Interface: I2S
- Power: 3.3 V – 5 V DC
Rs 850.00Rs 1,050.00PCM5102 DAC I2S Interface Decoder
Rs 850.00Rs 1,050.00 -
USB2.0 TO TTL SERIAL 6PIN CONVERTER CH340G
Quick Info :
- Built-in USB to TTL Transfer chip.
- Designed to be used for USB to TTL electronic projects.
- TTL interface output. easy to connect to your MCU.
Rs 490.00Rs 550.00USB2.0 TO TTL SERIAL 6PIN CONVERTER CH340G
Rs 490.00Rs 550.00 -
Micro Drone Propellors Pair 55mm
Quick Info :
- Size: 55mm (2.2 inch)
- Material: Glass Fiber Nylon
- Quantity: 2 pieces (1 pair)
- Shaft: 1mm (0.95mm hole)
- Motors: 6x15mm, 7x20mm, 8.5x20mm
- Weight: 2g each
- Colors: Red & Black (CW/CCW)
Rs 200.00Rs 300.00Micro Drone Propellors Pair 55mm
Rs 200.00Rs 300.00 -
MCP4725 12-Bit I2C DAC Module with EEPROM
Quick Info :
- Resolution: 12-bit (4096 steps)
- Interface: I²C
- Key Feature: Internal EEPROM
- Voltage Range: 2.7V – 5.5V
- Use: Analog Signal Generation
Rs 450.00Rs 490.00MCP4725 12-Bit I2C DAC Module with EEPROM
Rs 450.00Rs 490.00 -
TTL To RS485 Adapter UART Converter Module 3.3V 5V
Quick Info :
- MAX485 chip-based for reliable RS485 communication
- Compatible with 3.3V and 5V power supplies
- Built-in 120-ohm termination resistor (jumper selectable)
- RX/TX LED indicators for signal monitoring
Rs 230.00 -
PAM8403 3W Audio Amplifier
Quick Info:
- Supply Voltage: 5VDC
- 3W Output at 10% THD with a 4Ω Load and 5V Power Supply
Rs 130.00PAM8403 3W Audio Amplifier
Rs 130.00 -
-
-
KY-006 Passive Buzzer Module
Quick Info:
- Buzzer Type : Passive (tone controlled via code)
- Trigger Type : High Level
- Operating Voltage : 3.3V – 5V
- Operating Current : <25mA
- Frequency Range : 1.5kHz – 2.5kHz
- Interface Pins : 3 (Signal, VCC, GND)
- Compatibility : Arduino, ESP32, Raspberry Pi
- PCB Size : 18.5mm × 15mm
Rs 100.00Rs 150.00KY-006 Passive Buzzer Module
Rs 100.00Rs 150.00 -
AT24C256 I2C interface EEPROM Memory Module
Quick Info:
- Onboard chip AT24C256 chip
- Onboard the I2C communications required pull-up resistor
- All pins are leads and marked
- PCB board Dimensions : 36.5 (mm) x12 (mm)
Rs 200.00Rs 390.00AT24C256 I2C interface EEPROM Memory Module
Rs 200.00Rs 390.00 -
Rs 250.00
Rs 490.00Mini RS232 to TTL Level Converter Module
Rs 250.00Rs 490.00 -
SSOP 16PIN/SOP 16PIN to DIP Adapter PCB Module
Quick Info :
- Input: SSOP-16 / SOP-16 SMD packages
- Output: DIP-16 (2.54mm pitch)
- SSOP Pitch: 0.635mm
- SOP Pitch: 1.27mm
- PCB: FR4, 1.6mm thickness
- Compatible: Breadboards, DIP sockets
- Use: SMD to through-hole conversion
Rs 50.00Rs 80.00SSOP 16PIN/SOP 16PIN to DIP Adapter PCB Module
Rs 50.00Rs 80.00 -
915MHz Spring Antenna for RF95 LORA Module
Quick Info :
- Frequency Range : 915MHz ± 5MHz
- Gain : 2.15dBi
- Input Impedance : 50 Ω
- Connector Type : Soldering
Rs 450.00 -
RFM95W LoRa Radio Module 915MHz
Quick Info :
- Frequency Band : 915MHz
- Output Power : +20dBm
- Receiver Sensitivity : -148dBm
- Communication Interface : SPI
Rs 2,450.00RFM95W LoRa Radio Module 915MHz
Rs 2,450.00 -
Ultrasonic Mist Maker
Quick Info :
- Input Voltage : 24V
- Input Current : 0.8A
- Atomization Amount : 350ML/H
- Use Water Depth : 4-9cm
- Operating Temperature : 1-50
- Power Lead Length : 150cm
- Nozzle Size : 4.65~4cm
Rs 1,850.00Ultrasonic Mist Maker
Rs 1,850.00 -
USB to ESP8266 WIFI Module Adapter Board
Quick Info :
Rs 490.00USB to ESP8266 WIFI Module Adapter Board
Rs 490.00 -
VHM-314 Bluetooth Audio Receiver Module
Quick Info :
- Voltage: 3.7 – 5V DC
- Bluetooth Version: 5.0 (Backward compatible with Bluetooth 4.2, 4.1, 4.0)
- Transmission Distance: 15m (Visible)
- Audio Decoding: WAV, APE, FLAC, MP3
- Dimensions: 30mm x 30mm
Rs 350.00Rs 480.00VHM-314 Bluetooth Audio Receiver Module
Rs 350.00Rs 480.00 -
ULN2003 Stepper Motor Driver Board Module
Quick Info :
- High Voltage Outputs: 50V
- Inputs Compatible with Popular Logic Types (5V TTL – Arduino Compatible)
- Relay Driver Applications
Rs 230.00Rs 390.00ULN2003 Stepper Motor Driver Board Module
Rs 230.00Rs 390.00 -
2 Channel 3V Relay Module
Quick Info:
- Control Voltage : 3V DC
- Relay Type : Electromechanical (SPDT)
- Number of Channels : 2 (independently controlled)
- Contact Configuration : NO, NC, COM (per channel)
- Maximum AC Load : 250V AC / 10A (per channel)
- Maximum DC Load : 30V DC / 10A (per channel)
- Optocoupler Isolation : Yes (per channel)
- Compatible Platforms : ESP8266, ESP32, Arduino (3V logic)
Rs 390.00Rs 450.002 Channel 3V Relay Module
Rs 390.00Rs 450.00 -
1.3 Inch OLED Display Module 4 Pin IIC White
Quick Info:
- Display Size : 1.3 Inch
- Resolution : 128 x 64 Pixels
- Pixel Color : White
- Interface : IIC (I2C)
- Driver IC : SH1106
Rs 950.00Rs 1,100.001.3 Inch OLED Display Module 4 Pin IIC White
Rs 950.00Rs 1,100.00 -
TFT LCD Display Module 1.8″ SPI Interface 128×160
Quick Info :
- True TFT display with 262,144 vibrant colors
- 4-wire SPI interface – minimal pin usage
- Works with 3.3V and 5V systems
- Built-in microSD card slot for bitmap storage
- Compatible with Arduino, Raspberry Pi, ESP32
- Controllable LED backlight
- Compact 34.5×58.0mm PCB size
Rs 950.00Rs 1,250.00TFT LCD Display Module 1.8″ SPI Interface 128×160
Rs 950.00Rs 1,250.00 -
4-DOF Robot Arm Kit
Quick Info :
- Degree: 4 Degree of Freedom
- Material: Acrylic
- Compatible Servo: 4 Micro Servos MG90 (Not Included
Rs 1,400.00Rs 1,950.004-DOF Robot Arm Kit
Rs 1,400.00Rs 1,950.00 -
PC817 Optocoupler Isolation Board 3.6-30V
Quick Info:
- Optocoupler Type : PC817
- Drive Signal Voltage : 3.6V – 24V
- Output Voltage Range : 3.6V – 30V
- Output Logic : Jumper Configurable
Price range: Rs 350.00 through Rs 950.00 -
2.4 inch ILI9341 SPI TFT LCD Module w/ SD Card
Quick Info:
- Driver IC : ILI9341
- Resolution : 240 x 320 pixels
- Communication Interface : 4-wire SPI
- Storage Expansion : Built-in microSD card slot
Rs 2,100.00Rs 2,400.002.4 inch ILI9341 SPI TFT LCD Module w/ SD Card
Rs 2,100.00Rs 2,400.00 -
12V DC Relay Module High/Low Trigger 2/4/8CH
Quick Info:
- Channels : 2 / 4 / 8 (as selected)
- Relay Coil Voltage : DC 12V (separate supply required)
- Control Logic : 3.3V / 5V TTL
- Trigger Mode : High / Low (jumper selectable)
- Isolation : SMD Optocoupler per channel
- Contact Rating : AC 250V / 10A — DC 30V / 10A
- Contact Type : SPDT (NO + NC + COM)
Price range: Rs 400.00 through Rs 1,520.00 -
Nema17 Stepper Motor Bracket
Quick Info :
- Compatible Motor : NEMA17
- Material : Steel
- Finish : Black coated
- Thickness : 3 mm
Rs 280.00Rs 350.00Nema17 Stepper Motor Bracket
Rs 280.00Rs 350.00 -
Aluminium Gear Motor Bracket 37GB
Quick Info :
- Type: Motor Mounting Bracket
- Material: Aluminium Alloy
- Compatibility: 37GB(GA) DC Motors
- Dimensions: 47x40x43mm
Rs 280.00Rs 350.00Aluminium Gear Motor Bracket 37GB
Rs 280.00Rs 350.00 -
Air Humidifier Driver Board Mist Maker Cotton Stick
Quick Info :
- Product Type: Humidifier Driver Board with Cotton Stick
- Input Voltage: DC 5V
- Power Output: 5W – 12W
- Mist Output: High-efficiency ultrasonic mist generation
- Cotton Stick Length: 10 cm
- Material: PCB driver board And cotton filter stick
Rs 550.00 -
74HC4067 16-Channel Analog Multiplexer Module
Quick Info :
- 16 bi-directional channels
- Can be used as multiplexer or demultiplexer
- Channels can handle analog or digital signals
Rs 400.00 -
NE555 Pulse Generator Module
Quick Info :
- The working voltage: 5 ~ 12V
- Output amplitude: 4.2V V-PP(5v input) to 11.4V V-PP(12V input).
- Maximum output current: >=15mA (5V IN), >=35mA (12V IN)
Rs 250.00Rs 290.00NE555 Pulse Generator Module
Rs 250.00Rs 290.00 -
NE555 Adjustable Pulse Frequency Duty Cycle Module Square Wave Signal Generator
Quick Info :
Main chip: NE555
Input Voltage (VCC): 5V-15VDC
Input current:~100MA
Output amplitude: 4.2V V-PP to 11.4V V-PP. (Varies with VCC voltage)Rs 280.00
