Best Seller Items
-
-
Jumper Wire Male-Male 20cm
Quick Info :
- Connector : Male to Male
- 1 Cable : Rs. 6
- 1 Set (40pcs) : Rs. 240
Rs 6.00Jumper Wire Male-Male 20cm
Rs 6.00 -
2 – 10 Pin JST XH 2.54 Pitch Connector Cable and Base
Quick Info:
- Wire Type : 26AWG
- Pitch: 2.5mm±0.05
- length: 15cm
Rs 25.00 – Rs 75.00 -
Jumper Wire Male-Female 30cm
Quick Info :
- Connector : Male to Female
- 1 Cable : Rs. 8
- 1 Set (40pcs) : Rs. 320
Rs 8.00Jumper Wire Male-Female 30cm
Rs 8.00 -
Jumper Wire Male-Female 20cm
Quick Info :
- Connector : Male to Female
- 1 Cable : Rs. 6
- 1 Set (40pcs) : Rs. 240
Rs 6.00Jumper Wire Male-Female 20cm
Rs 6.00 -
LED 5mm Bulb Common Anode
Specification:
- 5mm Round Standard Directivity
- Color : Red, Blue, Green, White, Yellow
- UV Resistant : Eproxy
- Forward Current (IF): 30mA
- Forward Voltage (VF): 1.8V to 2.4V
Rs 4.00LED 5mm Bulb Common Anode
Rs 4.00
-
DHT11 Humidity and Temperature Sensor
Quick Info :
- Working Voltage : 3 to 5V DC
- Humidity Range : 20-80% humidity; ±5% accuracy
- Temperature Range : -20°C to 50°C temperature; ±2°C accuracy
Rs 390.00DHT11 Humidity and Temperature Sensor
Rs 390.00 -
Digital Audio Power Amplifier Module HW-710
Quick info :
- Output Power: 2x50W (stereo mode) or 100W (mono mode)
- Frequency Response: 20Hz to 20kHz
- Signal-to-Noise Ratio (SNR): ≥100dB
- Chip: TPA3116D2
- Power Supply Voltage: 12-24V DC
Rs 690.00 -
Digital Multimeter 830D series
Quick Info :
- DC : 200m-2000m-20-200-1000V ~ ±0.5%
- AC: 200-750V ~ ±1.0%
- DCA: 20u-2000u-20m-200m-10A ~ ±1.8%
- Resistance: 200-2000-20K-200K-2000KΩ ~ ±1.0%
Rs 1,190.00Digital Multimeter 830D series
Rs 1,190.00 -
Digital Voltmeter & Ammeter Dual Display
Quick Info :
- Size: 48mm x 29mm x 26mm.
- Display color: Red & Blue LED (dual display).
- Display: 0.28″ LED digital.
- Operating voltage: DC 4.5 ~ 30V.
- Measure voltage: DC 0 ~ 100V.
- Measure current: 10A (direct measurement, built-in shunt).
Rs 690.00Digital Voltmeter & Ammeter Dual Display
Rs 690.00 -
Dot Board Medium 14.5cm X 6.5cm
Quick Info :
- Type : Universal Prototyping Dot Board
- Material : High-quality FR4 fiberglass
- Size : 14.5cm x 6.5cm
- Hole Pitch : Standard 2.54mm (0.1 inch) spacing
- Hole Diameter : 1mm
Rs 120.00Dot Board Medium 14.5cm X 6.5cm
Rs 120.00 -
Double BTS7960 43A Motor Driver Module
Quick Info :
- Input Voltage: 6 ~ 27V
- Driver: Dual BTS7960 H Bridge Configuration
- Peak current: 43-Amp
Rs 1,490.00Double BTS7960 43A Motor Driver Module
Rs 1,490.00 -
-
Dual Screw Terminal Block
Quick info :
- Rating: 600V 15A
- Positions: 5, 8, 10, and 12
Rs 120.00 – Rs 230.00 -
-
Dupont Jumper Connectors
Quick Info :
- Connectors Housing + Male or Female Pin Connector
Rs 15.00 – Rs 105.00Dupont Jumper Connectors
Rs 15.00 – Rs 105.00 -
-
Electrical Glass Fuse
Quick Info :
- Available Amps: 5A, 10A, 20A
- Fast-acting, low breaking capacity
- 5mm x 20mm physical size
Rs 5.00Electrical Glass Fuse
Rs 5.00 -
Rs 5.00 – Rs 175.00
-
ELM327 Bluetooth Interface OBD2 Car Scanner
Quick info:
- Wireless Bluetooth Connectivity – Connects to Android, Windows, and some iOS devices for hassle-free diagnostics.
- Reads & Clears Error Codes (DTCs) – Quickly diagnose and fix engine issues.
- Supports Multiple Protocols – Works with ISO 9141-2, KWP2000, CAN Bus, and more.
- Works with Popular Apps – Compatible with Torque, Car Scanner, FORScan,
- Cost-Effective Diagnostic Tool – Saves money on mechanic visits by allowing DIY troubleshooting.
Rs 890.00 -
ESP 32 CAM Module
Quick Info :
- ESP32 SoC with Wi-Fi and BLE connectivity
- OV2640 2M pixel camera with connector included
- Micro SD card connector
- Reset button
Rs 2,290.00Rs 2,690.00ESP 32 CAM Module
Rs 2,290.00Rs 2,690.00 -
ESP32 Development Board
Quick Info :
- Dual core
- Wi-Fi and bluetooth
- This particular board has 30 or 38 pins.
- Built-in hall effect sensor and built-in temperature sensor.
Rs 1,590.00 – Rs 1,950.00 -
ESP32 S3 WROOM DEVKITC
Quick info:
- Dual-Core Xtensa® LX7 Processor – Runs at up to 240 MHz for high-performance computing.
- Wi-Fi 4 & Bluetooth 5 (LE) – Supports 2.4 GHz Wi-Fi and Bluetooth Low Energy (BLE) for wireless connectivity.
- USB OTG (Full-Speed) – Built-in USB 1.1 OTG for flashing, communication, and JTAG debugging.
Rs 2,290.00Rs 2,490.00ESP32 S3 WROOM DEVKITC
Rs 2,290.00Rs 2,490.00 -
ESP32-Cam Programmer Base Module
Quick info:
- Chipset: CH340
- Connectivity: Micro-USB
- IO Port: 9
- Power Supply(V): 5
Rs 390.00ESP32-Cam Programmer Base Module
Rs 390.00 -
ESP32-WROOM-32 Module
Quick Info :
- Two low-power Xtensa® 32-bit LX6 microprocessors
- 802.11 b/g/n (802.11n up to 150Mbps) Wi-Fi protocol
- BLUETOOTH® v4.2 BR/EDR and BLE
- SD card, UART, SPI, SDIO, I2C, LED PWM, Motor PWM, I2S, and IR module interfaces
- Hall sensor
- 2.7V to 3.6V operating voltage supply
Rs 1,275.00ESP32-WROOM-32 Module
Rs 1,275.00 -
ESP8266 ESP-01 WIFI module
Quick Info :
- 802.11 b/g/n
- Operating Voltage: 3.3V
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
Rs 590.00ESP8266 ESP-01 WIFI module
Rs 590.00 -
Fan Motor 20MM Bearing Type Copper SUOER
Quick Info :
- Model – YS 60
- Rated Power – 50W to 60 W
- Rated Voltage – 220V
- Capacitor – 1.2uf , 1.5uf , 1.8uf , 400V – 450V
- Rated Frequency – 50Hz
- RPM – 1200/r min
Rs 2,590.00Fan Motor 20MM Bearing Type Copper SUOER
Rs 2,590.00 -
Flame Sensor Module
Quick Info :
- Operating Voltage : 3.3V ~ 5.5V
- Infrared Wavelength Detection : 760nm ~ 1100nm
- Sensor Detection Angle : 60°
Rs 280.00Flame Sensor Module
Rs 280.00 -
FM Receiver Board V4M
Quick info:
- Wide Frequency Range – Supports 87.0 MHz to 108.0 MHz for clear FM reception.
- High Sensitivity – Low-noise RF input amplifier ensures strong signal reception.
- Excellent Audio Quality – 50 Hz to 18 kHz frequency response for crisp sound output.
- Compact & Lightweight – Ideal for integration into DIY electronics and audio projects.
- Easy to Integrate – Simple pin connections for quick setup in custom applications.
Rs 1,490.00FM Receiver Board V4M
Rs 1,490.00 -
FQA50N60 N-Channel MOSFET
Quick Info :
- Type: N-Channel MOSFET IGBT
- Collector-Emitter Voltage (V_CES): 600 V
- Gate-Emitter Voltage (V_GE): ±20 V
- Continuous Drain Current : 50A
- On-State Resistance : 0.18Ω
- 5 µs short-circuit capability
- Continuous Collector Current (I_C): 100 A (at 25°C), 50 A (at 100°C)
- Power Dissipation (P_D): 223 W (at 25°C), 89 W (at 100°C)
- High-speed switching capability
Rs 290.00FQA50N60 N-Channel MOSFET
Rs 290.00 -
FQPF7N65C N Channel MOSFET
Quick Info :
- Drain Source Voltage (Vdss) : 650V
- Continuous Drain Current (Id) : 7A
- Power Dissipation (Pd) : 52W
- Drain Source On Resistance (RDS(on)@Vgs,Id) : 1.4Ω@10V,3.5A
- Gate Threshold Voltage (Vgs(th)@Id) : 4V@250uA
- Type : N Channel
Rs 130.00FQPF7N65C N Channel MOSFET
Rs 130.00 -
FT232RL USB to TTL Converter
Quick Info :
- Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.
- Integrated +3.3V level converter for USB I/O
- Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
Rs 590.00FT232RL USB to TTL Converter
Rs 590.00 -
Glass Fuse Holder Panel Mount Fuse Socket
Quick Info :
- Item Name: Panel Mounted Fuse Holder
- Fit for: 5 x 20mm / 0.2 Inch x 0.79 Inch Fuses;
- Rated: AC 125V 15A; AC 250V 10A
Rs 55.00 -
Global PVC Electrical Insulation Tape
Quick Info :
- Material : Polyvinyl Chloride (PVC)
- Adhesive Type : Rubber-based Pressure-Sensitive
- Thickness : 0.18mm
- Width : 15mm
- Dielectric Strength : ≥ 600V/mil
- Color Options : Black
Rs 80.00 -
Glue gun 20W
Quick Info :
- Power : 20W
- Operating Voltage : 100-240V, 50/60Hz
- Heating Time : 3-5 minutes
- Glue Stick Diameter : 7mm-8mm
- Nozzle Type : Precision metal nozzle for controlled application
Rs 490.00Glue gun 20W
Rs 490.00 -
Glue gun 80W SD-A6
Quick Info :
- Voltage : 110-220v
- Power : 80W
- Glue stick size: 11mm (Large)
- On/Off Switch
Rs 1,590.00Glue gun 80W SD-A6
Rs 1,590.00 -
Glue Gun SD-A601
Specification :
- Model : SD-A601
- Color Options : White
- Power Consumption : 20W
- Input Voltage Range : 100V to 240V AC
- Frequency : 50-60Hz
- Melt Temperature : Approximately 190°C (±10°C)
Rs 690.00Glue Gun SD-A601
Rs 690.00 -
Glue stick 11mm
Quick Info :
- Diameter: 11mm
- Material: High-quality thermoplastic adhesive
- Melting Point: ~160°C
- Compatibility: Suitable for all standard 11mm hot glue guns
Rs 60.00Glue stick 11mm
Rs 60.00 -
Glue stick 7mm
Quick Info:
- Diameter: 7mm
- Material: High-quality thermoplastic adhesive
- Melting Point: Approximately 160°C
- Compatibility: Suitable for all standard 7mm mini hot glue guns
- Bonding Strength: Strong and durable adhesion
Rs 25.00Glue stick 7mm
Rs 25.00 -
GP AA Rechargeable NiMH Battery
Quick info :
Brand: GP
Voltage: 1.2V
Capacity: 2600mAH
Package: 4 x AA Rechargeable NiMH BatteriesRs 890.00Rs 990.00GP AA Rechargeable NiMH Battery
Rs 890.00Rs 990.00 -
GP AAA Rechargeable NiMH Battery
Quick info :
Brand: GP
Voltage: 1.2V
Capacity: 1100mAH
Package: 4 x AAA Rechargeable NiMH BatteriesRs 890.00Rs 990.00GP AAA Rechargeable NiMH Battery
Rs 890.00Rs 990.00