Best Seller Items
-
-
Jumper Wire Male-Female 30cm
Quick Info :
- Connector : Male to Female
- 1 Cable : Rs. 8
- 1 Set (40pcs) : Rs. 320
Rs 8.00Jumper Wire Male-Female 30cm
Rs 8.00 -
Jumper Wire Male-Male 20cm
Quick Info :
- Connector : Male to Male
- 1 Cable : Rs. 6
- 1 Set (40pcs) : Rs. 240
Rs 6.00Jumper Wire Male-Male 20cm
Rs 6.00 -
Jumper Wire Male-Female 20cm
Quick Info :
- Connector : Male to Female
- 1 Cable : Rs. 6
- 1 Set (40pcs) : Rs. 240
Rs 6.00Jumper Wire Male-Female 20cm
Rs 6.00 -
LED 5mm Bulb Common Anode
Specification:
- 5mm Round Standard Directivity
- Color : Red, Blue, Green, White, Yellow
- UV Resistant : Eproxy
- Forward Current (IF): 30mA
- Forward Voltage (VF): 1.8V to 2.4V
Rs 4.00LED 5mm Bulb Common Anode
Rs 4.00 -
Jumper Wire Male-Male 30cm
Quick Info :
- Connector : Male to Male
- 1 Cable : Rs. 8
- 1 Set (40pcs) : Rs. 320
Rs 8.00Jumper Wire Male-Male 30cm
Rs 8.00
-
-
DHT22 Temperature and Humidity Sensor
Quick Info :
- Operating Voltage : 3.5V to 5.5V
- Temperature Range : -40°C to 80°C
- Humidity Range : 0% to 100%
Rs 360.00Rs 570.00DHT22 Temperature and Humidity Sensor
Rs 360.00Rs 570.00 -
Logic Level Converter Bi-Directional Module 5V to 3.3V
Quick Info :
- 4 channels can convert up to 4 logic signals
- Can convert between 1.8V, 2.8V, 3.3V and 5V logic circuits
- Bi-directional so can work with bi-directional buses such as I2C
- Utilizes N-Ch MOSFET transistors for level translation
Rs 80.00 -
1N5408 3A 1000V General Purpose Diode
Quick Info :
- Maximum recurrent peak reverse voltage: 1000V
- Maximum average forward current: 3A
Rs 20.00 -
16-Channel PWM Servo Controller Module
Quick Info :
- 16 Channels of individually controllable PWM using PCA9685 Chip
- PWM / Ground / 5V pins for each servo
- I2C Interface
Rs 1,750.00Rs 1,950.0016-Channel PWM Servo Controller Module
Rs 1,750.00Rs 1,950.00 -
Rs 220.00 – Rs 250.00 -
-
OLED 128X64 0.96 inch Display Module
Quick Info :
- OLED Driver IC: SSD1306
- Resolution: 128 x 64
- Visual Angle: >160°
- Input Voltage: 3.3V ~ 6V
- Compatible I/O Level: 3.3V, 5V
Rs 750.00Rs 990.00OLED 128X64 0.96 inch Display Module
Rs 750.00Rs 990.00 -
RGB LED 5mm Common Anode
Quick Info :
- RGB Led Common Cathode
- Lens: 5mm Diameter / Diffused / Round
- R:620-625nm / G:515-520nm / B:450-455nm
Rs 15.00RGB LED 5mm Common Anode
Rs 15.00 -
Rs 350.00RGB SMD LED 8 Channel Module 5050 WS2812
Rs 350.00 -
FT232RL USB to TTL Converter
Quick Info :
- Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.
- Integrated +3.3V level converter for USB I/O
- Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
Rs 400.00Rs 590.00FT232RL USB to TTL Converter
Rs 400.00Rs 590.00 -
-
Electronic SCR 230V AC Voltage Regulator 2000W
Specifications :
- Input Voltage: 220V
- Maximum Power: 2000W
- Adjustable Voltage: 50V-220V
Rs 950.00Rs 1,250.00Electronic SCR 230V AC Voltage Regulator 2000W
Rs 950.00Rs 1,250.00 -
VL53L0X Laser Ranging Sensor Module
Quick Info :
- Supply Voltage: 2.6V to 5.5V
- Average active ranging sensor current: 19mA
- Interface: I2C
- Dimension: 13mm x 11mm
Rs 790.00Rs 1,250.00VL53L0X Laser Ranging Sensor Module
Rs 790.00Rs 1,250.00 -
-
KY-022 IR Receiver Module
Quick Info :
- Chip type: VS1838B
- Operating Voltage: 3.3V to 5V
- Current Consumption: 1.5mA peak
- Receiving angle: 90 °
- Reception distance: 17m
Rs 220.00KY-022 IR Receiver Module
Rs 220.00 -
INA219 Bi Directional Current Sensor Module
Quick Info :
- Power Input : 3.0V-5.5V
- Up to +26V target voltage
- 0.1 ohm 1% 2W current sense resistor
Rs 420.00Rs 950.00INA219 Bi Directional Current Sensor Module
Rs 420.00Rs 950.00 -
Coreless Micro DC Motor 720 7x20mm
Quick Info :
- Ultra-high speed: 20,000 RPM at 3.7V
- Coreless design for low noise and high efficiency
- Compact size: 7mm diameter x 20mm length
- Wide voltage range: 1V to 3.7V operation
- Low current consumption: 0.01A
- Precision 0.8mm shaft with 3.8mm length
- Ready-to-use with 5cm color-coded wire leads
Rs 390.00Rs 490.00Coreless Micro DC Motor 720 7x20mm
Rs 390.00Rs 490.00 -
TP4056 1S Battery Charger Type C
Quick Info :
- Input voltage: 4.35-6V (recommended voltage 5V)
- Charging current: 1 Amps
- Led indicator: Red is charging, Blue is full charged
- The board size: about 2.5 * 1.65 CM
Rs 130.00Rs 200.00TP4056 1S Battery Charger Type C
Rs 130.00Rs 200.00 -
SN74HC595N 8-Bit Shift Registers
Quick Info :
- : Serial to Parallel
- : 8bit
- : 16Pins
- : 2V
- : 6V
Rs 40.00SN74HC595N 8-Bit Shift Registers
Rs 40.00 - : Serial to Parallel
-
NRF24L01 2.4GHz Transceiver
QUICK OVERVIEW
- Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
- Built-in hardware CRC error detection, Multipoint communication address control.
- Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
- Built-in 2.4Ghz antenna
- Built-in voltage regulator
Rs 300.00Rs 490.00NRF24L01 2.4GHz Transceiver
Rs 300.00Rs 490.00 -
Plastic Wheel + Gear Motor
Quick Info :
- Name: TT motor
- Type: 1:48
- Speed: 45±10%r/min 90±10%r/min
- Rated voltage: 3V/6V
Rs 350.00Plastic Wheel + Gear Motor
Rs 350.00 -
1 channel 5V DC Relay Module
Quick Info :
- Channel : 1
- Coil sensitivity = 5VDC
- Maximum Contact capacity = 250VAC/10VDC
- Maximum Current capacity = 10A
Rs 190.00Rs 290.001 channel 5V DC Relay Module
Rs 190.00Rs 290.00 -
Coin Vibration Motor 10x3mm
Quick Info :
- Model : 1030
- Operating Voltage : 3 V DC
- Rated Current : Approx. 60 – 90 mA
- Diameter : 10 mm
- Thickness : 3 mm
Rs 180.00Rs 250.00Coin Vibration Motor 10x3mm
Rs 180.00Rs 250.00 -
4N35 Optocoupler
Quick Info :
- Package Type: 6 Pin Dip
- Transistor Type: NPN Photo Transistor
- Photo Transistor Max Collector Current(IC): 150mA
- Photo Transistor Max Collector-Emitter Voltage (VCEO): 30V
Rs 60.004N35 Optocoupler
Rs 60.00 -
NRF24L01 2.4GHz Transceiver Adapter Base
Quick Info :
- It can be used with NRF24L01 wireless module
- Add core nRF24L01+ Breakout Adapter with onboard 3.3V Regulator
- Onboard 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached nRF24L01+ module
- Allows for easy connection to nRF24L01+ modules
- Small power on SMD LED indicator
Rs 200.00Rs 250.00NRF24L01 2.4GHz Transceiver Adapter Base
Rs 200.00Rs 250.00 -
20N60 N Channel MOSFET Original
Quick Inf :
- Type of Control Channel: N -Channel
- Maximum Power Dissipation (Pd): 416 W
- Maximum Drain-Source Voltage |Vds|: 600 V
- Maximum Gate-Source Voltage |Vgs|: 30 V
- Maximum Drain Current |Id|: 20 A
Rs 290.0020N60 N Channel MOSFET Original
Rs 290.00 -
Magnet Button Cell 10X2
Quick Info :
- Diameter: 10mm
- Height: 2mm
Rs 50.00Magnet Button Cell 10X2
Rs 50.00 -
BC558 PNP Transistor
Quick Info :
- : PNP
- : 30V
- : 100mA
- : 500mW
Rs 15.00BC558 PNP Transistor
Rs 15.00 - : PNP
-
XY-J02 Timer Module With Relay
Quick info :
- Operating voltage: 6 – 30V DC
- 1 Channel delay triggered relay module
- Delay time: 0.1 second to 999 minutes
Rs 420.00Rs 590.00XY-J02 Timer Module With Relay
Rs 420.00Rs 590.00 -
-
AC-DC 12V 2A SMPS Power Adapter
Specifications :
- Input Voltage : AC 100 ~ 240V 50/60 HZ
- Output Voltage: DC 12V
- Output Current: 2A
- Plug Type : UK Plug
Rs 790.00Rs 990.00AC-DC 12V 2A SMPS Power Adapter
Rs 790.00Rs 990.00 -
Terminal Connector With Right Angle PCB Base 2-12 Pin
Quick Info :
- Pin Pitch: 5.08mm
- Pole Range: 2-Pin to 12-Pin
- Orientation: Right Angle
- Rating: 15A / 300V
- Function: Quick Disconnect Wire-to-Board
Rs 40.00 – Rs 245.00Terminal Connector With Right Angle PCB Base 2-12 Pin
Rs 40.00 – Rs 245.00 -
ADXL345 3-Axis Accelerometer Module
Quick Info :
- 3V-6V DC Supply Voltage
- On-board LDO Voltage regulator
- Built-in Voltage level convertor (MOSFET based)
- It can be interface with 3.3V or 5V Microcontroller.
Rs 690.00ADXL345 3-Axis Accelerometer Module
Rs 690.00 -
JST XH 2.0mm Connector Cable & Base 2 – 6 Pin
Quick Info:
- Type: JST-XH 2.0 mm
- Pins: 2P – 6P options
- Cable: 200 mm, 26 AWG
- Current: 3 A per pin
- Includes: Male + Female pair
Rs 20.00 – Rs 50.00JST XH 2.0mm Connector Cable & Base 2 – 6 Pin
Rs 20.00 – Rs 50.00
