Best Seller Items
-
1K – 100K Potentiometer
Quick Info :
- 1K, 5K, 10K, 50K, 100K Ohm
- Linear taper, carbon film type
- Single-Turn
Rs 30.00 – Rs 100.001K – 100K Potentiometer
Rs 30.00 – Rs 100.00 -
-
ESP8266 ESP-01 WIFI module
Quick Info :
- 802.11 b/g/n
- Operating Voltage: 3.3V
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
Rs 590.00ESP8266 ESP-01 WIFI module
Rs 590.00 -
NodeMCU Wi-Fi Development Board
Quick Info :
- Microcontroller: ESP8266
- Operating Voltage: 3.3V
- Input Voltage: 7-12V
- Digital I/O Pins (DIO): 16
- Analog Input Pins (ADC): 1
Rs 1,150.00Rs 1,450.00NodeMCU Wi-Fi Development Board
Rs 1,150.00Rs 1,450.00 -
ESP32 S3 WROOM DEVKITC
Quick info:
- Dual-Core Xtensa® LX7 Processor – Runs at up to 240 MHz for high-performance computing.
- Wi-Fi 4 & Bluetooth 5 (LE) – Supports 2.4 GHz Wi-Fi and Bluetooth Low Energy (BLE) for wireless connectivity.
- USB OTG (Full-Speed) – Built-in USB 1.1 OTG for flashing, communication, and JTAG debugging.
Rs 2,290.00Rs 2,490.00ESP32 S3 WROOM DEVKITC
Rs 2,290.00Rs 2,490.00 -
BMS 3S 40A Li-ion Battery Protection Board
Quick info :
- Applicable voltage: 12V
- Charge current: 20A (Max)
- Discharge current: 40A
- Overdischarge protection voltage: 2.5V ± 0.05V per cell
- Overcharge protection voltage: 4.25V ± 0.05V per cell
Rs 590.00
-
Micro SD card reader module
Quick Info:
- Control Interface: GND, VCC, MISO, MOSI, SCK, CS
- Size: 45 x 28mm
- Net weight: 6g
Rs 350.00Micro SD card reader module
Rs 350.00 -
Micro USB to DIP Converter Module
Quick Info :
- USB Type : Micro USB
- Header : 2.54mm
- Material : Plastic
- Size(L*W) : Approx. 26.06 x 22.93mm
Rs 100.00Micro USB to DIP Converter Module
Rs 100.00 -
Micro Wire Cutter Plier
Quick info :
- Max Cut = 1mm Copper Wire
- 5″ inches total length
- Spring Action
Rs 590.00Micro Wire Cutter Plier
Rs 590.00 -
Microphone XLR Jack 3 Pin
Quick Info :
- Microphone XLR Jack 3 Pin
Rs 290.00Microphone XLR Jack 3 Pin
Rs 290.00 -
Mini DC 3A Motor PWM Speed Controller
Quick Info :
- Operating Voltage: DC 4.5V-35V
- Control Power: 90W (maximum)
- Size: 30mm x 26mm x 14mm (Without Handle)
Rs 290.00Mini DC 3A Motor PWM Speed Controller
Rs 290.00 -
Mini Display Temperature Humidity Sensor
Quick Info :
- LCD Size: 35.7*16.8mm
- Operation Temperature: -15°c to 70°c
- Humidity measurement range: 10%~99%
Rs 590.00Mini Display Temperature Humidity Sensor
Rs 590.00 -
-
-
-
MJ2955 PNP Power Transistor
Quick Info :
- : PNP
- : 60V
- : 15A
- : 115W
Rs 225.00MJ2955 PNP Power Transistor
Rs 225.00 - : PNP
-
MM74HC245AN Octal 3-State Transceiver
Quick Info :
- Logic Type : Transceiver, Non-Inverting
- Number of Elements : 1
- Number of Bits per Element : 8
- Output Type : 3-State
Rs 110.00MM74HC245AN Octal 3-State Transceiver
Rs 110.00 -
MOC3020 Optotriac
Quick Info :
- Output Type : Triac
- Zero Crossing Circuit :No
- Number of Channels : 1
- Voltage – Isolation : 5000Vrms
- Voltage – Off State : 400 V
Rs 100.00MOC3020 Optotriac
Rs 100.00 -
-
MP1584 Mini 3A DC to DC Step down (Buck) Adjustable Module
Quick Info :
- Input Voltage: 4.5V – 28V
- Output Voltage: 0.8V – 20V
- Output Voltage Adjustment: On-board potentiometer
- Output Current: 1.8A (typical), 3.0A (max).
Rs 275.00 -
MPG55N06 MOSFET
Quick Info :
- Drain-to-Source Breakdown Voltage : 60 V
- ID Drain Current (continuous) at Tc=25°C : 55 A
- IDM Drain Current (pulsed) : 200 A
- VGS Gate to Source Voltage : +/-20 V
Rs 290.00MPG55N06 MOSFET
Rs 290.00 -
MPU-6050 3 Axis Gyroscope + Accelerometer Module
Quick Info :
- Model: GY-521
- Chip: MPU-6050
- Power supply: 3.3V
- Communication mode: standard IIC communication protocol
Rs 650.00Rs 790.00MPU-6050 3 Axis Gyroscope + Accelerometer Module
Rs 650.00Rs 790.00 -
MPU9250 9-DOF 3-Axis Accelerometer, Gyro, & Magnetometer
Quick Info :
- Acceleration, Gyroscope, and Magnetometer
- 9 DOF module
- Build-in ultra-low noise linear LDO voltage regulator.
- Built-in onboard filters, which reduce noise from the motor and other high current electronics.
Rs 1,590.00 -
MQ-135 Gas Sensor Module for Air Quality
Quick Info :
- Operating Voltage: 2.5V to 5.0V
- Power consumption: 150mA
- Detect/Measure: NH3, Nox, CO2, Alcohol, Benzene, Smoke
- Typical operating Voltage: 5V
Rs 490.00MQ-135 Gas Sensor Module for Air Quality
Rs 490.00 -
MQ-2 Gas Sensor Module for Combustible Gas
Quick Info :
- Operating Voltage is +5V
- Can be used to Measure or detect LPG, Alcohol, Propane, Hydrogen, CO and even methane
- Analog output voltage: 0V to 5V
- Digital Output Voltage: 0V or 5V (TTL Logic)
Rs 490.00 -
MQ-3 Gas Sensor Module for Alcohol
Quick Info :
- Power requirements: 5 VDC
- Current Consumption: 150mA
- DO output: TTL digital 0 and 1 ( 0.1 and 5V)
- AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detecting Concentration: 0.05-10mg/L Alcohol
Rs 590.00MQ-3 Gas Sensor Module for Alcohol
Rs 590.00 -
MQ-4 Gas Sensor Module for Methane Gas
Quick Info :
- Power requirements : VCC – 5V±0.1
- DO output : TTL digital 0 and 1 (0.1 and 5V)
- AO output : 0.1-0 .3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detection Gas : Natural gas/Methane
- Detection Concentration : 200-10000ppm (Natural gas / Methane)
Rs 590.00MQ-4 Gas Sensor Module for Methane Gas
Rs 590.00 -
MT3608 Mini DC-DC Step Up/Boost Module
Quick Info :
- Input voltage range 2.5 to 24V
- Output voltage range 5 to 28V
- Output current of up to 1.5A
Rs 230.00MT3608 Mini DC-DC Step Up/Boost Module
Rs 230.00 -
MT8870 DTMF Voice Module
Quick Info :
- MT8870 Frequency decoder chip
- Onboard 3.5mm input interface
- 5V Input
- Designed to be compatible with standard 2.54mm sockets
Rs 490.00MT8870 DTMF Voice Module
Rs 490.00 -
-
-
N20 Rubber Wheel
Quick Info :
- Dimensions: 43x19x3mm
- Material: Rubber and Plastic
Rs 200.00N20 Rubber Wheel
Rs 200.00 -
NE555 Adjustable Pulse Frequency Duty Cycle Module Square Wave Signal Generator
Quick Info :
Main chip: NE555
Input Voltage (VCC): 5V-15VDC
Input current:~100MA
Output amplitude: 4.2V V-PP to 11.4V V-PP. (Varies with VCC voltage)Rs 280.00 -
-
NEO-6M GPS Module with Active Antenna
Quick Info :
- Operating temperature range: -40 TO 85°CUART TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- Supply voltage: 3.3 V
Rs 1,290.00Rs 1,800.00NEO-6M GPS Module with Active Antenna
Rs 1,290.00Rs 1,800.00 -
NodeMCU Wi-Fi Development Board
Quick Info :
- Microcontroller: ESP8266
- Operating Voltage: 3.3V
- Input Voltage: 7-12V
- Digital I/O Pins (DIO): 16
- Analog Input Pins (ADC): 1
Rs 1,150.00Rs 1,450.00NodeMCU Wi-Fi Development Board
Rs 1,150.00Rs 1,450.00 -
NRF24L01 2.4GHz Transceiver
QUICK OVERVIEW
- Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
- Built-in hardware CRC error detection, Multipoint communication address control.
- Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
- Built-in 2.4Ghz antenna
- Built-in voltage regulator
Rs 490.00NRF24L01 2.4GHz Transceiver
Rs 490.00 -
NRF24L01 2.4GHz Transceiver Adapter Base
Quick Info :
- It can be used with NRF24L01 wireless module
- Add core nRF24L01+ Breakout Adapter with onboard 3.3V Regulator
- Onboard 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached nRF24L01+ module
- Allows for easy connection to nRF24L01+ modules
- Small power on SMD LED indicator
Rs 250.00NRF24L01 2.4GHz Transceiver Adapter Base
Rs 250.00 -
NRF24L01 2.4GHz Transceiver With Antenna
Quick Info :
- Voltage: 3-3.6V (recommended 3.3V) V.
- Maximum output power: +20dBm.
- Power-down mode current: 4.2uA.
- Operating Range: 1Km
Rs 950.00NRF24L01 2.4GHz Transceiver With Antenna
Rs 950.00 -
NTC Thermistor Module
Quick Info :
- Operating Voltage: 3.3V DC to 5V DC
- Output Current : 15mA
- PCB Size : 32 x 14mm
Rs 240.00NTC Thermistor Module
Rs 240.00