Skip to content
Quick Info:
IC : TXS0108E
Channels : 8 (all bi-directional, full-duplex)
VCCA (A side) : 1.2V – 3.6V (low voltage)
VCCB (B side) : 1.65V – 5.5V (high voltage)
Max Speed (Push-Pull) : 110Mbps
Max Speed (Open-Drain) : 1.2Mbps
Direction Sensing : Automatic (no DIR pin)
Protocols : UART / SPI / I²C / GPIO / SD card
Pin Pitch : 2.54mm breadboard compatible
Compatible : Arduino / ESP32 / Raspberry Pi / STM32
Rs 180.00Rs 220.00
Quick Info:
Chip : ADUM1201
Channels : 2 (Bidirectional)
Data Rate : DC to 25Mbps
Isolation Voltage : 2500Vrms
Rs 490.00Rs 550.00
Quick Info:
Interface : USB
Programming Socket : 40-pin DIP (ZIF)
Supported Chips : PIC10 / PIC12 / PIC16 / PIC18
Power Source : USB (no external supply)
Rs 2,550.00Rs 2,900.00
Quick Info:
Interface : USB (Full Speed)
Programming Protocol : ICSP
Supported Devices : PIC10/12/16/18/24, dsPIC
Included Accessory : ICSP Adapter Board
Rs 5,650.00Rs 6,250.00
Quick Info:
PC Interface : USB 2.0 Type-A Male
Device Interface : DB9 Male (RS232)
Data Transfer Rate : Up to 921.6Kbps
OS Support : Windows / macOS / Linux
Cable Length : Approximately 1 metre
Bus Powered : Yes (5V USB)
Plug and Play : Yes
Rs 1,580.00Rs 1,700.00
Quick Info:
Brand : Waveshare
Host Interface : USB Type-A
Device Interface : RS485 Screw Terminal
Baud Rate : 300bps – 921600bps
Transmission Distance : Up to 1200 metres
Power Supply : USB Bus Powered (5V)
OS Support : Windows / Linux / macOS
Direction Control : Automatic
Rs 3,250.00Rs 3,550.00
Quick Info :
Type: DVI-D ↔ HDMI passive adapter
Direction: Bidirectional
Resolution: Up to 1080p Full HD
Audio: Not supported
Power: None required (passive)
Compatible: PC, Raspberry Pi, monitors, projectors
Signal: Digital video only
Rs 550.00Rs 650.00
Quick Info :
Type: QFP to DIP Adapter Socket
Package: QFP100/TQFP100/LQFP100
Pin Pitch: 0.5mm
IC Size: 14×14mm body
Output: DIP100 (2.54mm pitch)
Rs 7,500.00Rs 7,900.00
Quick Info :
FT232RL+75176 chipset for stable communication
Automatic data flow control – no manual DE/RE control
Supports up to 32 devices on RS485 bus network
Wide baud rate: 300-921600bps with auto-detection
Switchable RS485/TTL modes via 4 jumpers
TVS protection and USB self-recovery features
Self-powered from USB – no external power needed
Rs 950.00
Quick Info :
Perfect for experimentation and prototype work
Brings all 9 pins of a DB9 connector to screw terminal blocks
Adapter used for communication debug
9 pcs signal line was all lead out, name and number clearly labeled;
Rs 290.00
Quick Info :
IC : SN65HVD230
Operating Voltage : 3.3V
Data Rate : Up to 1 Mbps
Standard Compliance : ISO 11898-2
ESD Protection : 16kV HBM (bus pins)
Rs 550.00Rs 690.00
Quick Info :
Type: 44-pin expansion breakout board
Compatible: ESP32-S3 development boards
Terminals: Screw terminal blocks (1→2 expansion)
Spacing: 25.4mm (44-pin)
Size: 80mm x 58mm
No Soldering Required
Rs 850.00Rs 950.00
Quick Info :
IC : HX711 (24-bit delta-sigma ADC)
Input Channels : 2 differential (Ch. A & Ch. B)
Programmable Gain : 32 / 64 / 128
Output Data Rate : 10 SPS / 80 SPS (selectable)
Operating Voltage : 2.7V – 5V DC
Operating Current : < 1.5mA
Interface : 2-wire (SCK + DT)
Operating Temp : -20°C to +85°C
Compatible Boards : Arduino / ESP32 / Raspberry Pi / STM32
Rs 240.00Rs 290.00
Quick Info :
1-to-8 Bidirectional Translating Switches.
Supports Hot Insertion.
Low Standby Current.
1-to-8 Bidirectional Translating Switches.
Rs 490.00
Quick Info :
MAX485 chip-based for reliable RS485 communication
Compatible with 3.3V and 5V power supplies
Built-in 120-ohm termination resistor (jumper selectable)
RX/TX LED indicators for signal monitoring
Rs 230.00
Quick Info :
Built-in USB to TTL Transfer chip.
Designed to be used for USB to TTL electronic projects.
TTL interface output. easy to connect to your MCU.
Rs 490.00Rs 550.00
Quick Info :
USB Interface : USB 2.0 Type-A
Serial Connector : DB9 Male (9-pin) / DB25 Male (25-pin)
Converter Chip : CH340 / PL2303
Baud Rate : 75 bps – 1 Mbps
RS232 Signals : TXD, RXD, RTS, CTS, DTR, DSR, DCD, RI, GND
Flow Control : Hardware (RTS/CTS) & Software (XON/XOFF)
Power : Bus-powered via USB
OS Support : Windows, macOS, Linux
Quick Info :
Compatible: ESP-01, ESP-07, ESP-12, ESP32
Interface: USB to Serial (CH340/CP2102)
Power: 3.3V regulated output
Features: Auto-reset, GPIO breakout, boot mode switches
Programming: Arduino IDE, ESP-IDF, MicroPython
Use: ESP development, testing, firmware flashing, IoT projects
Rs 1,350.00Rs 1,450.00
