Alphatronic
-
X9C103S Digital Potentiometer Module 10K
Quick Info :
- Total Resistance : 10KΩ
- Wiper Tap Positions : 100
- Step Resolution : ~101Ω per Step
- Operating Voltage : 3V – 5V DC
- Memory Type : Non-Volatile
Rs 640.00Rs 750.00X9C103S Digital Potentiometer Module 10K
Rs 640.00Rs 750.00 -
HX711 Load Cell Amplifier
Quick Info :
- IC : HX711 (24-bit delta-sigma ADC)
- Input Channels : 2 differential (Ch. A & Ch. B)
- Programmable Gain : 32 / 64 / 128
- Output Data Rate : 10 SPS / 80 SPS (selectable)
- Operating Voltage : 2.7V – 5V DC
- Operating Current : < 1.5mA
- Interface : 2-wire (SCK + DT)
- Operating Temp : -20°C to +85°C
- Compatible Boards : Arduino / ESP32 / Raspberry Pi / STM32
Rs 240.00Rs 290.00HX711 Load Cell Amplifier
Rs 240.00Rs 290.00 -
-
USB to TTL Converter CP2102 (5 Pin)
Quick Info :
- Standard USB type A male and TTL 5 pin connector.
- 5 pins for 3.3V, TXD, RXD, GND & 5V.
- Baud rates: 300 bps to 1.5 Mbps
Rs 790.00Rs 850.00USB to TTL Converter CP2102 (5 Pin)
Rs 790.00Rs 850.00 -
USB to RS232 Serial Adapter
Quick Info :
- USB Interface : USB 2.0 Type-A
- Serial Connector : DB9 Male (9-pin) / DB25 Male (25-pin)
- Converter Chip : CH340 / PL2303
- Baud Rate : 75 bps – 1 Mbps
- RS232 Signals : TXD, RXD, RTS, CTS, DTR, DSR, DCD, RI, GND
- Flow Control : Hardware (RTS/CTS) & Software (XON/XOFF)
- Power : Bus-powered via USB
- OS Support : Windows, macOS, Linux
-
FT232RL USB to TTL Converter
Quick Info :
- Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.
- Integrated +3.3V level converter for USB I/O
- Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
Rs 400.00Rs 590.00FT232RL USB to TTL Converter
Rs 400.00Rs 590.00 -
Logic Level Converter Bi-Directional Module 5V to 3.3V
Quick Info :
- 4 channels can convert up to 4 logic signals
- Can convert between 1.8V, 2.8V, 3.3V and 5V logic circuits
- Bi-directional so can work with bi-directional buses such as I2C
- Utilizes N-Ch MOSFET transistors for level translation
Rs 100.00Rs 150.00Logic Level Converter Bi-Directional Module 5V to 3.3V
Rs 100.00Rs 150.00 -
OV7670 Camera Module
Quick Info :
- Resolution 640×480 VGA
- Flicker (50/60 Hz) auto detection
- Onboard regulator, only single 3.3V supply needed
Rs 680.00Rs 925.00OV7670 Camera Module
Rs 680.00Rs 925.00 -
PAM8403 Mini 5V Digital Amplifier Board
Quick Info :
- Maximum output power: 3W*2(5V 4Ω)
- Built with switch Potentiometer
Rs 290.00Rs 320.00PAM8403 Mini 5V Digital Amplifier Board
Rs 290.00Rs 320.00 -
TDA7297 15W+15W Dual Channel Amplifier
Quick Info:
-
IC Chipset : TDA7297
-
Output Power : 15W + 15W
-
Operating Voltage : 6V – 18V DC
-
Amplifier Class : Class AB
-
Speaker Impedance : 4Ω – 8Ω
Rs 590.00TDA7297 15W+15W Dual Channel Amplifier
Rs 590.00 -
-
TDA2030 Audio Amplifier Module
Quick Info :
- 18 W mono amplifier circuit design
- On-board 10K potentiometer for volume adjustment
- Operating Voltage Range: 6 V to 12 V
Rs 290.00TDA2030 Audio Amplifier Module
Rs 290.00 -
PAM8406 5W Audio Amplifier
Quick Info :
- 5W Output at 10% (Total Harmonic Distortion) THD with a 2Ω Load and 5V Power Supply at Class-D Mode
- 3W Output at 10% THD with a 4Ω Load and 5V Power Supply
Rs 290.00Rs 390.00PAM8406 5W Audio Amplifier
Rs 290.00Rs 390.00 -
PAM8403 3W Audio Amplifier
Quick Info:
- Supply Voltage: 5VDC
- 3W Output at 10% THD with a 4Ω Load and 5V Power Supply
Rs 130.00PAM8403 3W Audio Amplifier
Rs 130.00 -
MT8870 DTMF Decoder Module 3.5mm Audio Jack
Quick Info :
- Decoder IC : MT8870
- Audio Input : 3.5mm audio jack
- Detectable Tones : 16 (0-9, A-D, *, #)
- Outputs : Q1-Q4 binary + StQ
- Operating Voltage : 5V DC
Rs 490.00 -
NodeMCU ESP8266 WiFi Dev Board (ESP-12E)
Quick Info :
- Wi-Fi Module : ESP-12E (ESP8266)
- Clock Speed : 80MHz – 160MHz
- Flash Memory : 4MB
- GPIO Pins : 17 (11 Usable)
- Operating Voltage : 3.3V
Rs 1,150.00Rs 1,450.00NodeMCU ESP8266 WiFi Dev Board (ESP-12E)
Rs 1,150.00Rs 1,450.00 -
ATtiny85 Development Board
Quick Info:
- Support for the Arduino IDE 1.0+ (OSX/Win/Linux)
- Power via USB or External Source
- Onboard 5V Regulator
- 6 I/O Pins
Rs 450.00ATtiny85 Development Board
Rs 450.00 -
Arduino Compatible Sensor Shield
Quick Info :
- Suitable for Arduino UNO and Mega Boards
- IIC, Bluetooth, SD Card Interface
- APC220 wireless RF module communication interface
- RB URF v1.1 ultrasonic sensors interface
- 128 x 64 LCD parallel and 32 servo controller interface
Rs 450.00Rs 550.00Arduino Compatible Sensor Shield
Rs 450.00Rs 550.00 -
Arduino Pro Mini (Atmega328 5V)
Quick Info :
- Microcontroller: ATmega328
- Board Power Supply: 3.35 -12 V (3.3V model) or 5 – 12 V (5V model)
- Circuit Operating Voltage: 3.3V or 5V (depending on model)
- Digital I/O Pins: 14
- PWM Pins: 6
Rs 980.00Rs 1,590.00Arduino Pro Mini (Atmega328 5V)
Rs 980.00Rs 1,590.00


















