Quick Info :
Power requirements : VCC – 5V±0.1
DO output : TTL digital 0 and 1 (0.1 and 5V)
AO output : 0.1-0 .3 V (relative to pollution), the maximum concentration of a voltage of about 4V
Detection Gas : Natural gas/Methane
Detection Concentration : 200-10000ppm (Natural gas / Methane)
Rs 590.00
Quick Info :
Power requirements: 5 VDC
Current Consumption: 150mA
DO output: TTL digital 0 and 1 ( 0.1 and 5V)
AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
Detecting Concentration: 0.05-10mg/L Alcohol
Rs 590.00
Quick Info :
Input Voltage : AC 100 ~ 240V 50/60 HZ
Output Voltage: DC 5V
Output Current: 2A
Plug Type : UK Plug
Rs 590.00
Quick Info :
802.11 b/g/n
Operating Voltage: 3.3V
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Rs 590.00
Quick Info :
MFRC522 chip based board
Operating frequency: 13.56MHz
Supply Voltage: 3.3V
Current: 13-26mA
Rs 590.00
Quick Info :
Operating voltage : 2.3V – 5.5V
Battery not included
Battery : CR2032
Rs 590.00
Quick Info :
Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.
Integrated +3.3V level converter for USB I/O
Integrated level converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
Rs 590.00
Quick Info :
The current sensor chip : ACS712
Current measuring : up to 5A
5V power supply, on-board power indicator
Rs 550.00
Quick Info :
The current sensor chip : ACS712
Current measuring : up to 20A
5V power supply, on-board power indicator
Rs 550.00
Quick Info :
Optical sensor: IR and red LED combined with a photodetector
Measures absorbance of pulsing blood
I2C interface plus INT pin
3.3V power supply complete pulse oximeter and heart rate sensor solution, simplifies design, integrated LEDs, photo sensor, and high-performance analog front
Rs 550.00
Quick Info :
Suitable for Arduino UNO and Mega Boards
IIC, Bluetooth, SD Card Interface
APC220 wireless RF module communication interface
RB URF v1.1 ultrasonic sensors interface
128 x 64 LCD parallel and 32 servo controller interface
Rs 550.00
Quick Info :
2 LEDs
2 buttons circuit
170 mini breadboard
Rs 500.00
Quick Info :
No. of Digits : 8
No. of Segments : 7
Supply Voltage Min : 4V
Supply Voltage Max : 5.5V
Rs 495.00
Quick Info :
On-board TTP226 IC
On-board 4 road level indicator.
Working voltage: 2 V to 5.5 V DC
PCB board size: 47.4 (mm) x 46 (mm)
Rs 495.00
Quick Info :
Measuring Range (humidity): 0% to 100% RH
Temperature Range: -40°C to +85°C
Air pressure range : 300-1100hPa (equi. to +9000 to -500m above sea level)
Temperature range: -40 to +85 °C
Rs 490.00
Quick Info :
Drain Source Voltage (Vdss) : 60V
Continuous Drain Current (Id) : 60A
Drain Source On Resistance (RDS(on)@Vgs,Id) : 11mΩ@10V,60A
Type : N Channel
Rs 490.00
Quick Info :
Main Chip: PAM8610
Power Range: DC 6V-15V (self-protection)
Recommended Voltage: DC 12V(2A)
Output Power: 10Wx2(8Ω) 15Wx2(4Ω)
Rs 490.00
Quick Info :
Interface Type: I2C.
Working voltage: 3.3~5.0V DC.
Temperature: -40ºC ~ 85ºC.
Humidity: 0 ~ 100%.
Rs 490.00
Quick Info :
Model No : LY2NJ/HH62P/JQX-13F
Coil Voltage: 12VDC
Control Voltage(V) :220VAC
Contact Structure: DPDT, with LED pilot
Terminal : 8 pins plug-in type
Rs 490.00
Quick Info:
Charging Voltage: 12.6V~13.6V
Continuous Discharge Current (upper limit): 20A
Continuous Charge Current (upper limit): 10A
Rs 490.00
Quick Info :
Material : Steel Colour : Blue Maximum Cutting Capacity : 0.8mm to 1.2mm
Rs 490.00
Quick Info :
Dimensions: 89mm X 65mm X 59mm
Rs 490.00
Quick Info :
Operating Voltage is +5V
Can be used to Measure or detect LPG, Alcohol, Propane, Hydrogen, CO and even methane
Analog output voltage: 0V to 5V
Digital Output Voltage: 0V or 5V (TTL Logic)
Rs 490.00
Quick Info :
Operating Voltage: 2.5V to 5.0V Power consumption: 150mA Detect/Measure: NH3, Nox, CO2, Alcohol, Benzene, Smoke Typical operating Voltage: 5V
Rs 490.00
QUICK OVERVIEW
Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
Built-in hardware CRC error detection, Multipoint communication address control.
Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
Built-in 2.4Ghz antenna
Built-in voltage regulator
Rs 490.00
Quick Info :
Operating Voltage is 4.7V to 5.3V
Current consumption is 1mA without backlight
Alphanumeric LCD display module, meaning can display alphabets and numbers
Consists of two rows and each row can print 16 characters.
Compatible with LCD to I2C Adapter Board
Rs 460.00Rs 490.00
Quick Info :
Built-in USB to TTL Transfer chip.
Designed to be used for USB to TTL electronic projects.
TTL interface output. easy to connect to your MCU.
Rs 490.00
Quick Info :
MT8870 Frequency decoder chip
Onboard 3.5mm input interface
5V Input
Designed to be compatible with standard 2.54mm sockets
Rs 490.00
Quick Info :
Voltage: 3.7 – 5V DC
Bluetooth Version: 5.0 (Backward compatible with Bluetooth 4.2, 4.1, 4.0)
Transmission Distance: 15m (Visible)
Audio Decoding: WAV, APE, FLAC, MP3
Dimensions: 30mm x 30mm
Rs 480.00
