Best Seller Items
-
1K – 100K Potentiometer
Quick Info :
- 1K, 5K, 10K, 50K, 100K Ohm
- Linear taper, carbon film type
- Single-Turn
Rs 30.00 – Rs 100.001K – 100K Potentiometer
Rs 30.00 – Rs 100.00 -
-
ESP8266 ESP-01 WIFI module
Quick Info :
- 802.11 b/g/n
- Operating Voltage: 3.3V
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
Rs 590.00ESP8266 ESP-01 WIFI module
Rs 590.00 -
NodeMCU Wi-Fi Development Board
Quick Info :
- Microcontroller: ESP8266
- Operating Voltage: 3.3V
- Input Voltage: 7-12V
- Digital I/O Pins (DIO): 16
- Analog Input Pins (ADC): 1
Rs 1,150.00Rs 1,450.00NodeMCU Wi-Fi Development Board
Rs 1,150.00Rs 1,450.00 -
LiPo Battery 3.7V 1200mAH
Quick Info :
- Battery Type : Lithium Polymer (LiPo)
- Voltage : 3.7V nominal
- Capacity : 1200mAh
- Size : 60mm X 25mm
- Charging Voltage : 4.2V (fully charged)
- Discharge Rate : 1C to 25C
Rs 1,990.00LiPo Battery 3.7V 1200mAH
Rs 1,990.00 -
LED Holder 5mm
Quick Info :
- Type : LED Holder
- Material : made from plastic And Nylon
- Size Compatibility : 5mm
- Mounting Method : Snap-in, screw-in
- Voltage Rating : Compatible with standard LED
Rs 15.00LED Holder 5mm
Rs 15.00
-
-
-
360 Degree Rotary Encoder Module
Quick Info :
- Incremental Encoder
- Supply Voltage: 3-5V
- Left/Right rotary output pulse, each circle with 20 pulse
- Built in 10k resistor
- Cycles per revolution (CPR): 20
Rs 350.00360 Degree Rotary Encoder Module
Rs 350.00 -
DS18B20 Temperature Sensor Module
Quick Info :
- Temperature Range : -55°C to +85°C
- Wire Interface : 1-wire interface
- 3.3 and 5V compatible
Rs 350.00DS18B20 Temperature Sensor Module
Rs 350.00 -
AC-DC 5V 700mA 3.5W
Quick Info :
- Output Voltage: DC5V (±0.1V)
- Output Current: 700mA
- Power: 3.5W
Rs 350.00AC-DC 5V 700mA 3.5W
Rs 350.00 -
TDA2030 Audio Amplifier Module
Quick Info :
- 18 W mono amplifier circuit design
- On-board 10K potentiometer for volume adjustment
- Operating Voltage Range: 6 V to 12 V
Rs 350.00TDA2030 Audio Amplifier Module
Rs 350.00 -
-
-
GSM PCB Trace Antenna
Quick Info :
- Low Freq. range – 820-960mHz
- High Freq. range – 1710-1990mHz
- Cable – RF1.13
- Connector – I-PEX
Rs 300.00GSM PCB Trace Antenna
Rs 300.00 -
1S 18650 Battery SMD PCB Holder
Quick Info :
Size W x L x H : 20.65 mm x 68.88mm x 14.86mm
Rs 300.001S 18650 Battery SMD PCB Holder
Rs 300.00 -
Magnet Block 30x20x5mm
Quick Info :
- Length: 30mm
- Width: 20mm
- Height: 5mm
Rs 300.00Magnet Block 30x20x5mm
Rs 300.00 -
-
DC Motor 180 3V – 6V
Quick info :
- Operating Voltage Range: 3V – 6V
- Torque: 0.2 – 0.5 Nm
- No-load Speed: 5000 – 15000 RPM
- Stall Current: 1 – 3 A
Rs 290.00DC Motor 180 3V – 6V
Rs 290.00 -
DB9 Female Screw Terminal to RS232 RS485 Conversion Board
Quick Info :
- Perfect for experimentation and prototype work
- Brings all 9 pins of a DB9 connector to screw terminal blocks
- Adapter used for communication debug
- 9 pcs signal line was all lead out, name and number clearly labeled;
Rs 290.00 -
Analog Hall Effect Sensor Module
Quick Info :
- Operating Voltage: 5V DC
- Current Draw: 8mA
- Dimensions: 18 x 15 x 5 mm (L x W x H)
Rs 290.00Analog Hall Effect Sensor Module
Rs 290.00 -
MC-38 Wired Magnetic Door Window Switch
Quick Info :
- Connection type : Normally Open
- Actuation Distance (mm) : 15 ~ 25
- Connecting cable length (cm) : 30
Rs 290.00MC-38 Wired Magnetic Door Window Switch
Rs 290.00 -
-
NE555 Pulse Generator Module
Quick Info :
- The working voltage: 5 ~ 12V
- Output amplitude: 4.2V V-PP(5v input) to 11.4V V-PP(12V input).
- Maximum output current: >=15mA (5V IN), >=35mA (12V IN)
Rs 290.00NE555 Pulse Generator Module
Rs 290.00 -
-
Keypad Flexible 4 Keys
Quick Info :
- Arduino and Raspberry Pi compatible
- 4-key membrane switch pad has 5 pin female header on end of flat cable
- White sticker on back can be peeled off for adhesive mounting
Rs 285.00Keypad Flexible 4 Keys
Rs 285.00 -
MP2307DN Mini 3A DC to DC Step down (Buck) Adjustable Module V2
Quick Info :
- Input voltage : 4.75 – 23VDC
- Adjustable Output voltage : 1.0 – 17VDC
- Output Amps : 3A surge current, 1.8A continuous rated current
Rs 280.00 -
MP1584 Mini 3A DC to DC Step down (Buck) Adjustable Module
Quick Info :
- Input Voltage: 4.5V – 28V
- Output Voltage: 0.8V – 20V
- Output Voltage Adjustment: On-board potentiometer
- Output Current: 1.8A (typical), 3.0A (max).
Rs 275.00 -
Project Enclosure 100mm X 64mm X 47mm
Quick Info :
- Dimensions: 100mm X 64mm X 47mm
Rs 260.00Project Enclosure 100mm X 64mm X 47mm
Rs 260.00 -
-
STM8 Development Board STM8S003F3P6
Quick Info
- On-board STM8S003F3P6 chip
- On-board SWIM connector for programming
- On-board reset switch
- Reserved external crystal oscillator soldering place
- AMS1117-3.3 voltage regulator for convering 5 V power supply to 3.3 V
- Mini USB connector for powering the board
- Board Size: 36.5 x 21.6 mm
Rs 250.00STM8 Development Board STM8S003F3P6
Rs 250.00 -
-
SX1308 DC-DC Step-Up Adjustable Power Module
Quick Info :
- Maximum input voltage: DC 2-24V
- Maximum output voltage: DC 2-28V
- Maximum current output: 2A
Rs 250.00 -
FPV Pan/Tilt Camera Mount
Quick Info :
- Weight: 38g
- Size: 70x38x36mm
- Compatible Servos : Servo 9g or Servo MG90S
Rs 250.00FPV Pan/Tilt Camera Mount
Rs 250.00 -
Keypad Flexible 12 Keys
Quick Info :
- 12-key membrane switch pad has 7 pin female header on end of flat cable
- White sticker on back can be peeled off for adhesive mounting
Rs 250.00Keypad Flexible 12 Keys
Rs 250.00 -
-
MAX485 RS485 to TTL module
Quick Info :
- Working voltage：5V
- Connect to 2P terminal on board, for wiring of RS-485 to communicate
Rs 220.00MAX485 RS485 to TTL module
Rs 220.00 -
Project Enclosure 100mm X 60mm X 27mm
Quick Info :
- Dimensions: 100mm X 60mm X 27mm
Rs 200.00Project Enclosure 100mm X 60mm X 27mm
Rs 200.00 -
-
Car Automobile Fuse Holder 2-30A
Quick info :
- The fuse holder works with any 2-30 amp blade fuse.
- The structure of the fuse holder provides extra protection against water and dust.
Rs 190.00Car Automobile Fuse Holder 2-30A
Rs 190.00