Quick Info:
Pressure Sensor : MPS20N0040D
ADC Chip : HX710B
Pressure Range : 0-40KPa
Interface : Digital (VCC, OUT, SCK, GND)
Rs 400.00Rs 550.00
Quick Info :
Chip : MPU-6050
Communication : I2C
Operating Voltage : 3-5V
Axes : 6 (Gyro + Accel)
ADC Resolution : 16-bit
Rs 730.00Rs 790.00
Quick Info :
Acceleration, Gyroscope, and Magnetometer
9 DOF module
Build-in ultra-low noise linear LDO voltage regulator.
Built-in onboard filters, which reduce noise from the motor and other high current electronics.
Rs 1,090.00
Quick Info :
Operating Voltage: 2.5V to 5.0V Power consumption: 150mA Detect/Measure: NH3, Nox, CO2, Alcohol, Benzene, Smoke Typical operating Voltage: 5V
Rs 450.00Rs 520.00
Quick Info:
Sensor Type : Semiconductor (SnO₂)
Target Gas : Hydrogen Sulfide (H2S)
Detection Range : 1 – 200 ppm
Output Type : Analog + Digital
Operating Voltage : 5V DC
Preheat Time : ≥ 24 hours (initial use)
Pins : 4 (VCC, GND, AOUT, DOUT)
Rs 2,900.00Rs 3,500.00
Quick Info:
Detection Gas : Ammonia (NH₃)
Detection Range : 5 – 500 ppm
Operating Voltage : 5V DC
Output Type : Digital & Analog
Interface : 4-pin (VCC, GND, DO, AO)
Compatible With : Arduino, ESP32, Raspberry Pi
Rs 10,500.00Rs 12,000.00
Quick Info :
Operating Voltage is +5V
Can be used to Measure or detect LPG, Alcohol, Propane, Hydrogen, CO and even methane
Analog output voltage: 0V to 5V
Digital Output Voltage: 0V or 5V (TTL Logic)
Rs 420.00Rs 490.00
Quick Info :
Power requirements: 5 VDC
Current Consumption: 150mA
DO output: TTL digital 0 and 1 ( 0.1 and 5V)
AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
Detecting Concentration: 0.05-10mg/L Alcohol
Rs 480.00Rs 590.00
Quick Info :
Power requirements : VCC – 5V±0.1
DO output : TTL digital 0 and 1 (0.1 and 5V)
AO output : 0.1-0 .3 V (relative to pollution), the maximum concentration of a voltage of about 4V
Detection Gas : Natural gas/Methane
Detection Concentration : 200-10000ppm (Natural gas / Methane)
Rs 590.00
Quick Info:
Sensor Type : MQ-5
Detectable Gases : H2, LPG, CH4, CO, Alcohol
Operating Voltage : 5V DC
Output Type : Analogue & Digital
Detection Range : 200 – 10000 ppm
Compatible Platforms : Arduino, Raspberry Pi, ESP32
Rs 480.00Rs 550.00
Quick Info :
Power requirements : VCC – 5V±0.1
DO output : TTL digital 0 and 1 (0.1 and 5V)
AO output : 0.1-0 .3 V (relative to pollution), the maximum concentration of a voltage of about 4V
Detection Gas: Carbon Monoxide
Rs 525.00Rs 590.00
Quick Info :
Sensor Type: VOC Gas Sensor
Model: MQ138
Detection Range: 5-500 ppm
Heater Voltage: 5.0V DC or AC
Applications: Gas Alarms, Portable Detectors
Rs 10,500.00Rs 10,900.00
Quick Info:
Model : MS-282AX
Compatible Battery : 18650 Li-ion (3.7V)
Number of Slots : 2 (Independent Channels)
Charge Termination : 4.2V per Cell
Input Voltage : 100–240V AC
Protection : Overcharge, Over-Current, Short Circuit
Rs 1,400.00Rs 1,450.00
Quick Info :
Input voltage range 2.5 to 24V
Output voltage range 5 to 28V
Output current of up to 1.5A
Rs 180.00
Quick Info :
Chip: MT3608
Input: 2-24V DC (Micro USB or terminals)
Output: 5-28V DC (adjustable)
Max Current: 2A
Efficiency: Up to 93%
Use: Voltage boosting for electronics projects
Rs 180.00Rs 250.00
Quick Info :
Model: MT60 3-Pin Motor Connector
Pins: 3 x 3.5mm
Type: Male + Female pair
Current: 60A per phase
Housing: Nylon (prevents shorts)
Use: Brushless motors, ESC, drones, RC vehicles
Rs 350.00Rs 400.00
Quick Info :
Decoder IC : MT8870DS
Decoded Tones : 16 (0–9, *, #, A–D)
Output : 4-bit binary (Q1–Q4) + StD pin
Audio Input : 3.5mm AUX jack
Clock : 3.579545 MHz crystal oscillator
Operating Voltage : 5V DC (TTL logic)
LED Indicators : Yes (4 × output state LEDs)
Compatible Boards : Arduino / ESP32 / PIC / STM32
Rs 490.00
Quick Info:
LED Size : 5mm Through-Hole
Lens Type : Clear / Diffused
Number of Colors : 7 (automatic cycling)
Control : Built-in IC (no external control)
Forward Voltage : 3.0V – 3.4V (typical)
Forward Current : 20mA (max)
Viewing Angle : 60°
Rs 15.00Rs 20.00
