ESP32-Cam Programmer Base Module
Rs 390.00
Quick info:
- Compatible Module : ESP32-CAM (AI-Thinker)
- USB-to-Serial Chip : CH340G
- Connector Type : Micro USB
- Onboard Controls : RESET button, BOOT (IO0) button
- Power Supply Output : 5V/3.3V regulated
Frequently Bought Together
- This item: ESP32-Cam Programmer Base Module(Rs 390.00)
- ESP32 CAM Module with OV3660 Camera Module(Rs 3,150.00)
- Micro USB Cable 1m(Rs 300.00
Rs 450.00) - ESP32 S3 DevKitC-1 N16R8 WiFi BLE Dev Board(Rs 1,980.00
Rs 2,290.00)
The ESP32-CAM Programmer Base Module is a must-have add-on board that solves one of the biggest headaches makers face with the ESP32-CAM: it has no built-in USB port for uploading code. This base board, also known as the ESP32-CAM-MB or CH340 burner shield, lets you plug your ESP32-CAM directly into it, connect a single micro USB cable, and upload sketches straight from the Arduino IDE without wiring up a separate FTDI adapter or juggling jumper wires. It’s built around the CH340G USB-to-Serial converter chip, providing a stable and reliable data bridge between your computer and the ESP32-CAM during flashing and debugging.
Designed for hobbyists, students, and IoT developers, this programmer base handles the tricky boot-mode sequencing automatically in most cases, making it far easier to get your camera-based projects running. It includes onboard RESET and BOOT buttons for manual control when needed, a power indicator LED, and a voltage regulator that supplies clean, stable power to the ESP32-CAM during operation. Whether you’re building a Wi-Fi enabled security camera, a face-recognition project, a wildlife monitoring cam, or any other ESP32-CAM based IoT application, this base module dramatically speeds up your development workflow and removes the frustration of manual wiring. Simply seat your ESP32-CAM onto the pin headers, plug in the USB cable, and you’re ready to compile and upload.
Specification:
- Compatible Module : ESP32-CAM (AI-Thinker)
- USB-to-Serial Chip : CH340G
- Connector Type : Micro USB
- Onboard Controls : RESET button, BOOT (IO0) button
- Power Supply Output : 5V/3.3V regulated
- Power Indicator : LED
- Baud Rate Support : Up to 115200 bps (typical)
- Interface : UART (TX/RX)
