Quick Info :
Transmitter Operating Voltage: +5V only
Transmitter Operating current: 9mA to 40mA
Operating frequency: 433 MHz
Transmission Distance: 3 meters (without antenna) to 100 meters (maximum)
Rs 390.00
Quick Info :
Stackable design, easy to plug into the ARDUINO development board.
Coupled with the Arduino Bluetooth Bee Bluetooth module, and other Bluetooth devices can communicate Wirelessly.
Coupled with the XBee module, you can achieve two or more sets of communication between Arduino or Arduino and PC Communications.
Rs 750.00
Quick Info :
802.11 b/g/n
Operating Voltage: 3.3V
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Rs 520.00
Quick Info:
Bluetooth v2.0+EDR
2.4GHz ISM band frequency
Supported baud rate: 9600 (default), 19200,38400, 57600, 115200, 230400, 460800.
Speed: Asynchronous: 2.1Mbps(Max) / 160 kbps, Synchronous: 1Mbps/1Mbps
Power supply: 3.6V to 6V DC
Rs 1,090.00Rs 1,350.00
Quick Info :
Bluetooth v2.0+EDR
2.4GHz ISM band frequency
Default baudrate: 9600
Power supply: 3.6V to 6V DC
Rs 1,090.00Rs 1,350.00
Quick Info :
MFRC522 chip based board
Operating frequency: 13.56MHz
Supply Voltage: 3.3V
Current: 13-26mA
Rs 590.00
Quick Info :
Operating temperature range: -40 TO 85°CUART TTL socket
EEPROM to save configuration settings
Rechargeable battery for Backup
Supply voltage: 3.3 V
Rs 1,290.00Rs 1,800.00
QUICK OVERVIEW
Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
Built-in hardware CRC error detection, Multipoint communication address control.
Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
Built-in 2.4Ghz antenna
Built-in voltage regulator
Rs 490.00
Quick Info :
It can be used with NRF24L01 wireless module
Add core nRF24L01+ Breakout Adapter with onboard 3.3V Regulator
Onboard 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached nRF24L01+ module
Allows for easy connection to nRF24L01+ modules
Small power on SMD LED indicator
Rs 250.00
Quick Info :
Voltage: 3-3.6V (recommended 3.3V) V.
Maximum output power: +20dBm.
Power-down mode current: 4.2uA.
Operating Range: 1Km
Rs 950.00
Quick Info :
Credit Card Size, 13.56MHz, 1K Bytes Memory, ISO14443A, Read/Write protect by password, easy to program.
Compatible with RC522 and PN532 readers.
White card, card number not printed, No magnetic stripe, no holes. Each card individually packaged.
Discounts applicable for more than 100 Card
Rs 95.00
Quick Info :
2G Quad-band 850/900/1800/1900MHz
Receive and make calls using the speaker and microphone outputs
Receive and send SMS
Listen to FM radio broadcasts
Rs 1,290.00
Quick Info :
Quad-band 850/900/1800/1900MHz – connect onto any global GSM network with any 2G SIM
Send and receive SMS messages.
Send and receive GPRS data (TCP/IP, HTTP, etc.).
Scan and receive FM radio broadcasts.
Minimum Power supply required : 5v 2A Power Supply
Rs 2,390.00
Quick Info :
Compatible with standard Arduino and Arduino Mega
Selectable interface between hardware serial port and software serial port
Support TCP/UDP protocols
Rs 4,100.00
Quick Info :
LoRa ™ Spread Spectrum modulation technology
Constant RF power output at + 20dBm-100mW voltage change
High sensitivity: down to -148dBm
Half-duplex SPI communication
Programmable bit rates up to 300kbps
Supports FSK, GFSK, MSK, GMSK, LoRa ™ and OOK modulation modes
127dB RSSI dynamic range
Automatic RF signal detection, CAD mode and very high speed AFC
Packet engine with CRC up to 256 bytes
Small footprint dual-row stamp-hole patch package
Shielded housing
Rs 1,650.00
Quick Info :
Operating voltage:5V (supplied from the Arduino Board)
Ethernet Controller: W5500 with internal 32K buffer
Connection speed: 10/100Mb
Connection with Arduino on SPI port
Rs 4,390.00
Quick Info :
Support Card Type: Read-only ID card (EM4100, IM4001)
Support frequency: 125KHz
Reader Time: <0.2s
Read Range: 3-10cm
Rs 990.00
Quick Info :
Material: ABS
Dimension(LxWxH): 43.7×30.5×5.3mm
Response Frequency: 13.56MHz
Chip type: FM1108 Fudan Chip
Rs 100.00